Brodit 512288 Datasheet

Product 512288

512288 Active holder with cig-plug. With tilt swivel.

The active holder charges your BlackBerry when it is in the holder. The holder is attached onto a tilt swivel and

can be adjusted in order to avoid light reflection. Connects to the vehicle’s cigarette lighter socket, 12/24 Volt.

Attach onto a ProClip Mounting Platform.

EAN: 7320285122888

Item no 512288 fits:

BlackBerry Torch 9850

BlackBerry Torch 9860

1(2)

1. 2.

INSTALLATION INSTRUCTIONS

4.3.

Please, carefully read all instructions and review the pictures before attaching the holder.

1. Unscrew the screw in the center of the holder. Remove the holder from the tilt swivel base plate.

2. Place the base plate onto the desired position. Screw the base plate into place by using the enclosed screws.

3. Start to thread the center screw into the base plate. When you connect with the nut, pull the holder towards

you to prevent the nut from spinning around. Tighten the screw firmly. Then loosen the screw sligthly for easier

angling/rotation of the holder.

4. The holder is in place. Slide the device into the holder. To remove the device from the holder, slide it out. Use

the tilt swivel to adjust the angle, or rotate the holder into a horizontal/landscape position if desired.

2(2)