CURT 12230 Owner's manual

CURT
Brand
CURT
Model
12230
Category
Wall & ceiling mounts accessories
Type
Owner's manual

CURT 12230 is a weight-carrying hitch designed for use with Lexus LS 400 vehicles manufactured between 1995 and 2000. It has a gross load capacity of 3,500 pounds and a tongue weight capacity of 300 pounds. The hitch is designed to be installed without drilling and uses existing weld nuts on the vehicle's frame. It comes with all necessary hardware and detailed installation instructions. The hitch is backed by a limited lifetime warranty.

CURT 12230 is a weight-carrying hitch designed for use with Lexus LS 400 vehicles manufactured between 1995 and 2000. It has a gross load capacity of 3,500 pounds and a tongue weight capacity of 300 pounds. The hitch is designed to be installed without drilling and uses existing weld nuts on the vehicle's frame. It comes with all necessary hardware and detailed installation instructions. The hitch is backed by a limited lifetime warranty.

Parts List
DESCRIPTIONPART NUMBERQTYITEM
HHCS,M12x1.25,40CL10.9,YZ10-1027761
WASHER,LOCK,1/2,YZ
30-0015362
WASHER,FLAT,7/16,YZ
30-0016663
GROSS LOAD CAPACITY WHEN USED AS A WEIGHT CARRYING HITCH: LBS. TRAILER WEIGHT & LBS. TONGUE WEIGHT.
***DO NOT EXCEED VEHICLE MANUFACTURER'S RECOMMENDED TOWING CAPACITY.***
WARNING: ALL NON-TRAILER LOADS APPLIED TO THIS PRODUCT MUST BE SUPPORTED BY AUXILIARY STABILIZING STRAPS.
** FAILURE TO PROPERLY SUPPORT NON-TRAILER LOADS WILL VOID PRODUCT WARRANTY**
HAVING INSTALLATION QUESTIONS? CALL TECHNICAL SUPPORT AT
1-877-287-8634
HITCH WEIGHT: LBS.
INSTALL TIME
PROFESSIONAL: MINUTES
NOVICE (DIY): MINUTES
INSTALL NOTES:
INSTALLATION STEPS
PERIODICALLY CHECK THIS RECEIVER HITCH TO ENSURE THAT ALL FASTENERS
ARE TIGHT AND THAT ALL STRUCTURAL COMPONENTS ARE SOUND.
Curt Manufacturing Inc., warrants this product to be free of defects in material and/or workmanship at the time of retail purchase by the original purchaser. If the product is found to be defective,
Curt Manufacturing Inc., may repair or replace the product, at their option, when the product is returned, prepaid, with proof of purchase. Alteration to, misuse of, or improper installation of
this product voids the warranty. Curt Manufacturing Inc.'s liability is limited to repair or replacement of products found to be defective, and specifically excludes liability for incidental or
consequential loss or damage.
3,500 300
23
30
95-00 LEXUS LS 400
07/02/2020
12230
60
36225 / 367219
1. Under the rear of the car, locate the exhaust mufflers on the driver and passenger sides of the car. The
mufflers are supported at the rear of the vehicle by flexible supports and brackets bolted into the chassis
with three 12mm screws per bracket.
2. Temporarily remove these brackets from the chassis on the driver and passenger sides of the car. Position
the hitch on the vehicle at the same mounting points. Remount these brackets at the bottom of the hitch
brackets on both sides of the vehicle. Mount the hitch using fasteners provided.
3. Torque all 12mm fasteners to 86 lb-ft.
-NO DRILLING REQUIRED
-REMOVE EXHAUST BRACKETS
1
2
3
EXISTING WELD NUTS
(BOTH SIDES)
PASSENGER SIDE
MUFFLER SUPPORT
DESIGNED FOR USE WITH
BALL MOUNT # D-55001/ 45501
  • Page 1 1

CURT 12230 Owner's manual

CURT
Brand
CURT
Model
12230
Category
Wall & ceiling mounts accessories
Type
Owner's manual

CURT 12230 is a weight-carrying hitch designed for use with Lexus LS 400 vehicles manufactured between 1995 and 2000. It has a gross load capacity of 3,500 pounds and a tongue weight capacity of 300 pounds. The hitch is designed to be installed without drilling and uses existing weld nuts on the vehicle's frame. It comes with all necessary hardware and detailed installation instructions. The hitch is backed by a limited lifetime warranty.

Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents