Southbend BECT-12 Operating instructions

Brand: Southbend

Model: BECT-12

Type: Operating instructions

southbend

A MIDDLEBY COMPANY

OWNER'S MANUAL

INSTALLATION

USER'S GUIDE

ELECTRIC COUNTER TILTING SKILLET

MODEL: BECT-12

These instructions should be read thoroughly before attempting installation. Set up. installation and

Performance Check should be performed by a qualified service technician. The Manufacturer.

Southbend (1100 Old Honeycutt Rd.. Fuquay-Varina, North Carolina 27526), informs you that unless

the installation instructions for the above described Southbend product are followed and performed by

a qualified service technician, (a person experienced in and knowledgeable concerning the installation

of commercial gas and/or electrical cooking equipment) then the terms and conditions of the

Manufacturer's Limited Warranty will be rendered void and no warranty of any kind shall apply.

If the equipment has been changed, altered, modified or repaired by other than a qualified service

technician during or after the 12-month limited warranty period, then the manufacturer shall not be

liable for any incidental or consequential damages to any person or to any property which may result

from the use of the equipment thereafter. Some States do not allow the exclusion or limitation of

incidental or consequential damages, so the above limitation or exclusion thereto may not apply to

you.

In the event you have any question concerning the installation, use, care, or service of the product,

write Customer Service Department, Southbend Corporation. 1100 Old Honeycutt Rd., Fuquay-

Varina, North Carolina 27526.

OWNERS MANUAL

ELECTRIC

COUNTER

TILTING

SKILLET

Model Capacity

ECTS-12 12 gallon

55 liter

INDEX

We suggest that this entire Manual be read thoroughly and that all Instructions be followed

carefully.

SECTION PAGE DESCRIPTION

1 2 Installation Instructions, Service Connections

2 3 Operation Instructions, Temperature settings

3 4 Cleaning Instructions

4 5 Parts Lists

5 11 Wiring Diagrams

INSTALLATION INSTRUCTIONS

Electric Counter Tilting Skillet

SET UP

a) Ascertain correct position of skillet for tilting purposes on working surface. Approximately 30" (761 mm) Co front

of base from wall. Be sure skillet tilts easily.

b) Secure skillet by bolts -provided Co properly leveled working surface.

1.1

c) Seal skillet to table top with Silastic or other sealing compound.

SERVICE CONNECTION

a) All internal wiring of the skillet is complete.

b) Make a waterproof electrical connection from incoming lines to the control box.

c) Ground skillet Co terminal provided in control housing.

d) A wiring diagram is provided inside the control housing cover panel.

e) All skillets have been factory tested for control and electrical heating elements.

f) Check for proper operation.

1.2

WIRING DIAGRAM LOCATED INSIDE CONSOLE COVER

SECTION: 1

MODEL: ECTS

OPERATION INSTRUCTIONS

SECTION: 2 MODEL: ECTS Electric Counter Tilting Ski

OPERATION

a) Ascertain that unit has been electrically connected and that circuit breakers are on.

b) Place power switch in "ON" position.

c) Set the thermostat dial Co high (#10).

d) Preheat the unit and allow it to cycle thus equalizing heat across the entire surface.

e) Cooking should be done at various temperature settings on the dial as determined by the user.

f) Water will boil faster with the optional cover on.

8) Check that skillet optional level bar, on right side of control panel, moves in and out easily. This bar

provides two set positions, level and slightly tilted.

2.1

h) At end of cooking, return thermostat to "OFF" position, turn power switch "OFF", remove food and allow

Co soak for ease of cleaning.

Thermostat Settings

Simmering 1-4

Sautéing 5-6

Searing 7-8

Pan Frying 8-9

Grilling 9-10

CLEANING INSTRUCTIONS

SECTION: 3

MODEL: ECTS Electric Counter Tilting Skillet

CLEANING

The Electric Counter Tilting Skillet (ECTS) should be cleaned AFTER EACH USE.

a) Soak cooking surface Co remove any food stuck Co the surface.

b) Wash entire skillet surface with a mild detergent and water.

c) Check Chat pouring spout, cover, and sides of unit as well as cooking surface are clean.

3.1

d) Rinse entire unit and dry.

NEVER SPRAY WATER INTO ELECTRIC CONTROLS

Southbend BECT-12 Operating instructions

Southbend BECT-12 Operating instructions

Southbend BECT-12 Operating instructions

Related papers

Other documents