2. Rugged Ridge
  3. 13201.10

Rugged Ridge 13201.10 Installation guide

  • Hello! I've reviewed the installation instructions for the Rugged Ridge Seat Adjuster Bracket for Jeep TJ and LJ models. This document provides a step-by-step guide on how to install the bracket using Rugged Ridge XHD seats, including details on cable routing, bracket securing, and spring connections. I'm ready to answer any questions you have about the installation process.
  • Which seats are compatible with the Seat Adjuster Bracket?
    What Jeep models is this bracket compatible with?
    Where should the cable be connected on the adjuster bracket?
Jeep® Seat Adjuster Bracket (Left-Right Seat 2003 - 2006 TJ , LJ)
Page 1
13201.10Rev (1) 11/11/2010
Step 1. Remove seat from factory
riser.
Step 4. Connect cable to adjuster
bracket. Cable should be
connected to back hole of
bracket. (pic.4)
P/N: 13201.10 TJ Seat Adjuster Bracket
Item List:
(1) Universal Seat Adjuster Bracket (1) Return Spring
(1) M8 Bolt
(1) M8 Large Flat Washer
(1) M8 Small Flat Washer
(1) Nylon Spacer
pic.1
Step 2. Disconnect seat slid-fold
cable and reroute under
seat riser and through
front plastic retainer loop.
(pic.2)
pic.2
Step 5. Bracket will be secured to
factory rear threaded seat
mount. (pic.5)
pic. 3
pic.4
Step 8. Tighten M8 bolt (Do Not Over Tighten). Move adjuster
arm to insure it moves freely. (pic.8)
Step 7. Place large M8 Flat washer onto M8 bolt. Put a small
amount of thread lock on bolt and secure to seat riser.
(pic.7)
pic.5 pic.6
NOTE: Adjuster has been designed to function with all
Rugged Ridge XHD seats. Following instructions
explain correct routing of return spring around
XHD steel mounting spacer.
pic.7 pic.8
pic.9
Step 9: Following instructions supplied with XHD seat, mount
seat to riser. Note location of adjuster bracket to steel
mounting spacer. Bracket should be located behind
spacer (pic.9). Oil all moving and sliding parts at this time.
Step10: Connect spring to adjuster bracket as shown in (pic.9),
Loop spring around steel mounting spacer and connect to
seat wave spring. (pic.10)
Step 3: Connect cable to rear cross
member. (pic.3)
Step 6. Place small M8 flat washer
over threaded hole. Place
Nylon spacer over small
washer. Place adjuster
bracket over spacer. (pic.6)
NOTE: Seat Adjuster Bracket has been designed to work with Rugged Ridge XHD seats. Will not work with factory
or other manufactures aftermarket seats.
Step11: With seat mounted check slide and fold function.
repeat steps 1-11 for other side. pic.10
/