2. BLOTZ
  3. B10_MC_003

BLOTZ B10_MC_003, B10-MC-003 Assembly Instructions

  • Hello! I've reviewed the instructions for assembling the Barracks Hut B10-MC-003 model. The document provides a clear, step-by-step guide on how to construct the model from its individual pieces, using PVA glue and a modeling knife. I'm ready to answer your questions about the assembly process.
  • What type of glue is recommended for assembly?
    What tool is needed to remove parts from the sprue?
    Is there a trick how to hold parts while glue dries?
Barracks Hut
B10-MC-003
Please read these instructions fully before starting construction.
PVA or equivalent glue will be required to stick sections together.
Sand paper can be used to gently clean any joints.
A sharp modelling knife will be required to remove sections from the sprue.
Please use knives with due care and remember to cut away from yourself at all times.
During the construction of this model, you may find it convenient to use pegs / elastic bands to hold pieces in place while
you allow glue to dry.
Remove the base and end pieces from the sprue.
Glue the end pieces to the base – etched detail
facing outwards.
Take the two side pieces.
Then glue them into place as shown above.
Take the roof pieces.
Glue the triangular supports inside the roof as
shown.
Sit the roof onto the hut.
The completed building.
/