State GTS-540P-NIH, GTS-540P-PIH, GT-540P-NEH, GT-540P-PEH User manual

Brand: State

Model: GTS-540P-NIH, GTS-540P-PIH, GT-540P-NEH, GT-540P-PEH

Type: User manual

Temperature Remote Controller 100276687 (TM-RE43)

For your safety and the safety of the owners, please read these instructions carefully before installation.

Follow these instructions exactly. After installation, please give this manual to the owner.

Be sure that the following items are included with the remote controller.

Temperature

Remote Controller

Screws Manual

Qty: 1

Qty: 2

Qty: 1

*In addition to the above items, a connecting cable comes with the remote controller that is included with the

water heater.

FOR YOUR SAFETY

INSTALLATION

This remote controller is NOT waterproof.

Do not install in high temperature environments, steamy conditions (such as a bathroom),

outdoors, in direct sunlight, or within the reach of children.

Make sure the remote controller does not come into contact with water or oil.

Failure to observe these warnings could result in electrical shock.

• Do not place the remote controller cable close to other wires from other products.

• Do not extend the remote controller cable more than 400 feet (122 m).

WARNING

5M5007

2000536344 (REV. A)

INCLUDED ACCESSORIES*

1. Take the Frame off of the remote controller with a flat head screwdriver. (Fig. A and B)

2. Attach the Metal plate on the wall with two provided screws. (Fig. B)

3. If you use another cable, crimp the Fork terminals to the wires. (Fig. C)

4. Open the Plastic cover and tighten the two Fork terminals beneath the two Remote controller terminal

screws on the back of the Main unit (Fig. D-1). Cut out the inlet for the cable from the bottom of the main

unit (Fig. D-2). Insert the cable through the inlet.

5. Close the Plastic cover (Fig. D-1) and then hook the Main unit to the Fixing bracket on the Metal plate. (Fig. B)

6. Attach the Frame back onto the remote.

7. Connect the Remote controller cable to the remote controller terminal on the computer board.

See TEMPERATURE REMOTE CONTROLLER in the Installation Manual for details.

Fig. A

Press and twist flat

head screwdriver

against the cutout.

Twist

Fig. B

Cut out the paron using pliers.

Frame

Main unit

Metal plateAached short screws

3-1/4 inch

(83.5 mm)

Hook B to

the Fixing

bracket on A.

A + B

Plasc

cover

Back side of the remote

Remote controller terminals

Remote controller cable

Two fork terminals

Fig. D-1

Remote controller cable

1-3/8 Inch

Fig. C

1-5/8 Inch

Fork Terminals

Inlet for the remote

controller cable

Cut out

Fig. D-2

State GTS-540P-NIH, GTS-540P-PIH, GT-540P-NEH, GT-540P-PEH User manual

State GTS-540P-NIH, GTS-540P-PIH, GT-540P-NEH, GT-540P-PEH User manual

State GTS-540P-NIH, GTS-540P-PIH, GT-540P-NEH, GT-540P-PEH User manual

Related papers

Other documents