Golden Lighting 3071-1P GG Installation guide

Brand: Golden Lighting

Model: 3071-1P GG

Type: Installation guide

Assembly Instructions: 3071-1P (Athena)

IMPORTANT:

• ALL INSTALLATION WORK SHOULD BE DONE BY ACCREDITED PROFESSIONAL.

• SHUT OFF POWER SUPPLY AT FUSE OR CIRCUIT BREAKER!

• USE ONLY THE SPECIFIED BULBS. DO NOT EXCEED THE MAXIMUM WATTAGE!

PREPARING FOR INSTALLATION

Remove all of the contents from the carton. See the important

notes above. Shut off the power at the circuit breaker and

completelyremovetheoldxturefromtheceiling,includingthe

oldmountingstrap.

Fromthepartsbagremovethemountingstrapassembly.One

endofnipple(F)shouldbeattachedtomountingstrap(A)with

hexnutandwasher(C&D)inplace.Theotherendshould

havecanopyloop(H)attached.Attachmountingstrap(A)to

thejunctionboxusingmountingscrews(B)andascrewdriver.

Tightensecurely.Unscrewcanopyloopcollar(I)fromcanopy

loop (H). Pass canopy (G) over the mounted canopy loop to

testtheheight.Approximatelyhalfofthecanopyloop’sexterior

threadsshouldbeexposed,andthecanopyloopcollarshould

tsnuglyontothecanopyloop.Removecanopy(G)andadjust

theheightofnipple(F)andcanopyloop(H)untilthedesired

heightisreached.Removecanopy(G)andcanopyloop(H).

ASSEMBLING THE FIXTURE

Bymeasuring,determinethecorrectnumberofchainlinks

neededforproperhangingheight.Ifnecessary,useapairof

plierstoopenandremoveanyexcesschain(J).Attachone

chainconnector(K)toeachendofchain(J).Twistthesidelock

to secure in place. Use one of chain connectors (K) to attach

chain(J)totoploop(L)andclosethechainconnector.Feed

thexture’swiresupthroughthechain(everythreelinksorso),

pullingthewiresuntiltaut.Usethefreechainconnector(K)to

attachchain(J)tocanopyloop(H).Untwistcanopyloopcollar

(I) to allow canopy (G) to be added to the chain. Feed the wires

upthroughthechain.Allowcanopy(G)todropdownontothe

chain/wire.

CONNECTING THE WIRES

Haveanassistantsupportthexture’sweightwhilecompleting

thewiring.Cutawayanyexcesswireaddingatleast8to10

inchesofwiretothedesiredlength.Threadthexture’swires

throughcanopyloop(H)andnipple(F).Attachthexture’swires

tothepowersupplywiresfromthejunctionbox.Connectblack

toblack(orsmooth);whitetowhite(orribbed);groundtoground

(greenorcopper).Twisttheendsofthewirepairstogether,then

twist on a wire connector. Make sure all twists are in the same

direction.Ifthereisnogroundwire(greenorcopper)fromthe

junctionbox,locategroundscrew(E)onmountingstrap(A)and

wrapthexture’sgroundwirearoundthegreengroundscrew

(E).Useascrewdrivertosecuregroundscrew(E)ontothe

mountingbracket.Tuckallwiresneatlyintothejunctionbox.

FINISHING THE INSTALLATION

Pushcanopy(G)uptotheceilingandslidecanopyloopcollar(I)

upbeneaththecanopy.Tightlythreadcanopyloopcollar(I)onto

canopy loop (H) to secure canopy (G) in place.

Installalightbulbinaccordancewiththexture’sspecications.

Donotexceedthemaximumrecommendedwattage.

Your installation is now complete. Turn on the power and test

thexture.

CLEANING TIPS

Treat the xture gently! Regular cleaning will reduce the need for deep cleaning. For regular cleaning, turn off the light and wipe down the

xture with a clean lint-free cotton or microber cloth. Never spray cleaner directly onto the xture.

For Customer Service, contact

the place of purchase to arrange

for replacement parts.

Golden Lighting 3071-1P GG Installation guide

Golden Lighting 3071-1P GG Installation guide

Golden Lighting 3071-1P GG Installation guide

Related papers

Other documents