2. Johnson & Starley
  3. Q-VENT HR160-260 MVHR

Johnson & Starley Q-VENT HR160-260 MVHR User Instructions

  • Hello! I'm a chat assistant and I have read the Users Instructions for the Johnson & Starley HR 160 and HR 260 ventilation systems. This manual explains how the system provides whole house ventilation with heat recovery. I'm ready to answer any questions you may have about its features, controls, or operation.
  • How does the Q-Vent HR160/260 system work?
    Where is the stale air drawn from?
    How can I boost the ventilation?
    How often does the Q-Vent HR160/260 unit need to be serviced?
RELIABILITY YOU CAN TRUST
Johnson & Starley
Publication No. ZZ 1358
September 2010
USERS INSTRUCTIONS
Rhosili Road, Brackmills, Northampton NN4 7LZ
Main Switchboard Tel: 01604 762881 Fax: 01604 767408
Spares Tel: 01604 707012 Fax: 01604 764879
Service Tel: 01604 707011 Fax: 01604 707017
www.johnsonandstarley.co.uk
1. INTRODUCTION
The Q-Vent HR160/260 system provides whole house mechanical ventilation to living areas and
bedrooms. The heat from the Q-Vent HR160/260 is recovered from stale contaminated air drawn
from bathrooms and utility rooms in conjunction with stale air from the kitchen. The Q-Vent
HR160/260 uses a high performance heat exchanger that recovers heat and uses it to temper
the incoming fresh air.
This type of system complies with Approved Document F of the Building Regulations F1 Means
of Ventilation.
Note: Installation of the Q-Vent HR160/260 will have been commissioned and balanced by a
competent person.
2. INSTRUCTIONS FOR USE
2.1 Turn on the Q-Vent HR160/260 appliance at the fused
spur.
2.2 The Q-Vent HR160/260 unit will now commence
extraction at the minimum set speed.
2.3 To manually boost the Q-Vent HR160/260 unit when
required rotate the control knob on the boost control
(A) to the desired setting. When the boost is no longer
required rotate the control knob to the original position.
2.4 The Q-Vent HR160/260 unit may be fitted with
additional remote automatic boost controls that will
automatically boost the airflow to a predetermined
extract rate.
2.5 The period of time that the unit will run at boost speed
will depend upon the type of automatic boost control
fitted.
2.6 Servicing of the Q-Vent HR160/260 unit is required annually.
SPEED CONTROL
A
HIGH EFFICIENCY VENTILATION SYSTEM
with Heat Recovery
HR 160 & HR 260
/