Johnson & Starley Q-VENT CE50 User Instructions

Brand
Johnson & Starley
Model
Q-VENT CE50
Type
User Instructions
1. INTRODUCTION
1.1 The Q-Vent CE50 is a Central Extract System that extracts stale or humid air from wet rooms, typically kitchens,
bathrooms and utility rooms and is exhausted to outside. A boost facility is provided to enable higher rates of extract
when required.
1.2 This type of system complies with Approved Document F of the Building Regulations F1 Means of Ventilation.
1.3 Installation of the Q-Vent CE50 unit will have been commissioned and balanced by a competent person.
1.4 This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental
capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning
use of the appliance by a person responsible for their safety.
1.5 If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly qualified
persons in order to avoid a hazard.
2. INSTRUCTIONS FOR USE
2.1 Turn on the appliance at the fused spur.
2.2 The unit will now commence extraction at normal speed.
2.3 To manually boost the unit when required press the switch on the
boost control to boost. When boost is no longer required press the
switch on the boost control to normal.
2.4 The Q-Vent CE50 unit may be fitted with additional remote
automatic boost switches that will automatically boost the airflow to
a predetermined extract rate.
2.5 The period of time that the unit will run at boost speed will depend
upon the type of automatic boost control fitted.
2.6 Maintenance of the Q-Vent CE50 unit is required annually to clean
the fan assembly.
Publication No. ZZ 1517
September 2014
Q-VENT CE50
Central Extract System
USERS INSTUCTIONS
Rhosili Road, Brackmills, Northampton NN4 7LZ
Tel: 01604 762881 Fax: 01604 767408
Spares Tel: 01604 707012
Service Tel: 01604 707011
www.johnsonandstarley.co.uk
sustainable solutions under one roof
HEATING HOT WATER VENTILATION
Johnson and Starley prides itself on its ability to supply spare parts quickly and efciently. If your service engineer indicates a problem in obtaining a spare part, advise him to
contact Johnson and Starley Spares Department at the address below.
FIGURE 1.
BOOST CONTROL
(not supplied with the unit)
  • Page 1 1

Johnson & Starley Q-VENT CE50 User Instructions

Brand
Johnson & Starley
Model
Q-VENT CE50
Type
User Instructions
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents