Thank you for choosing Obaby. To ensure that your travel cot is used in accordance with
these instructions, please read them fully.
This travel cot conforms to BS EN 716 and is guaranteed for 12 months from the date
of purchase against manufacturing defects. If, however you have any problems, please
contact your Obaby retailer from whom you purchased your product, who will take
appropriate action.
Your child’s safety may be affected if you do not follow these instructions.
WARNING: A child’s safety is your responsibility
WARNING: Be the aware of the risk of open re and other sources of strong
heat, such as electric bar res, gas res, etc. in the near vicinity of the cot
WARNING: Do not use the cot if any part is broken, torn or missing and use
only spare part approved by the manufacturer
WARNING: Do not leave anything in the cot or place the cot close to
another product, which could provide a foothold or present a danger of
suffocation or strangulation, e.g. Strings, blind/curtain cords, etc
WARNING: Do not use more than one mattress in the cot
• Do not use the travel cot without the mattress
• The depth of the mattress should not reduce the side height above it to less
than 500mm
• Failure to extend the top rails and lock them securely creates a safety risk.
Always check the rails are fully engaged before use
• To prevent injury from falls, if the child can stand unaided or is able to climb
out of the cot, the cot shall no longer be used for that child
• For correct and safe tting of a additional mattress to be used with this
product the length and width shall be such that the gap between the mattress
and the sides and ends does not extend 30mm
• Do not use the travel cot is any part is broken, torn or missing and use only
spare parts approved by the manufacturer
ROUTINE CARE & MAINTENANCE
- This travel cot requires regular maintenance by the user
- For cleaning, use only a mild detergent and warm water
- DO NOT USE BLEACH
- DO NOT USE any abrasive substances
- From time to time, check your travel cot for loose screws, worn parts, torn
material or stitching. Replace or adjust the parts as needed.
Due to constant updating and improvements, some components may occasionally differ slightly from
the images shown in these instructions. We reserve the rights to change the specications of any
products without prior notice. If you need any assistance please contact your Obaby retailer from
whom you purchased your product, who will take appropriate action.
Safety Warnings Getting to know your Travel Cot
Top bars Release button
Mattress base
23
www.obaby.co.uk www.obaby.co.uk
Folding your Travel Cot
Press
Release the velcro tabs on the underside of the travel cot and remove the mattress
(g.7 & 8).
Using the pull tab in the centre of the base, lift the base of the travel cot until the sides
are slack (g.9).
Whilst pushing the release buttons in the centre of each top bar, one at a time, gently lift
then lower the bars to release the side supports (g.10 & 11), repeat for all 4 sides.
Gather the feet and sides together, then wrap the mattress around the outside and
secure using the velcro tabs (g.12), place into the storage bag.
g. 7
g. 10
g. 8
g. 11
g. 9
g. 12
Setting up your Travel Cot
Unzip the storage bag and remove the travel cot (g.1).
Unfasten the velcro tabs and remove the outer mattress then spread the feet apart
(g.2).
Grasp the top bars, one at a time and lift up until they lock into place (g.3), repeat for
all 4 sides.
Push down in the centre of the base until at (g.4).
Place the mattress base into the bottom of the cot, padded side upwards (g.5).
Thread the velcro tabs on the underside of the mattress through the holes in the base of
the travel cot and secure underneath the travel cot (g.6).
g. 1
g. 4
g. 2
g. 5
g. 3
g. 6
Press
Lift
“Click”
45
www.obaby.co.uk www.obaby.co.uk
Fitting your Bassinette (optional)
Guide the support rods into the pockets in the base of the bassinette fabric (g.19).
Slot the two corresponding support rod sections together, ensuring they are secure and in
a straight line (g.20 & 21).
Place the mattress base on top of the support rods (g.22), push the mattress down to
ensure it is at (g.23 & 24).
g. 19
g. 22
g. 20
g. 23
g. 21
g. 24
Fitting your Bassinette (optional)
Set up your travel cot following the instructions on page 4 as far as g.4.
Losely lay the bassinette fabric inside the travel cot. Push the clips onto the top bars of
the travel cot all the way around the edge, ensuring they are all secure (g.13 & 14).
Lift the fabric over each corner as shown (g.15 & 16).
Push the retaining clips onto the corner bars of the travel cot (g 17 & 18).
g. 13
g. 16
g. 14
g. 17
g. 15
g. 18
Press
Press
67
www.obaby.co.uk www.obaby.co.uk
/
