SMITH SYSTEM 179901 Assembly Instructions

Cross Brace

INSTRUCTIONS

Form #179901 Rev. 9/2006

PLANNER ACTIVITY QUICK INS T ALL GUIDE

STEP 1: Place table top laminate face

down on a smooth clean surface.

STEP 2: Using the connector bolts found

in the leg set box loosely attach the

channel to the legs. (Do not tighten

connector bolts past finger tight at this

point.)

STEP 3: Using supplied allen wrench

adjust the legs to desired height.

STEP 4: Carefully rotate frame unit and

place flat against top using predrilled

holes in the top for aligment. (For larger

units the help of a second person will

be required)

STEP 5: Using supplied #10 wood screws

loosely attach the legs and cross brace

to the table. (Do not completely tighten

screws at this point).

STEP 6: Now go back and completely

tighten connector bolts, once they are

tight completely tighten wood screws

into the table.

* Please note, doing any of these steps

out of order could cause the legs to

sit bowed on table, take care to follow

instructions completely and in order.

#10 Wood Screw