Audio System for iPhone
SR150iP
WARRANTY PROCEDURE
v1.5.2: DEC 2011
Please read the owner’s manual carefully and ensure that you have followed the correct installation and operating
procedures.
1. Please read this warranty card.
2. Keep your purchase receipt to enable you to proceed quickly in the event of a Warranty Service.
3. If you require Warranty Service, please contact the TEAC Customer Support Hotline at 1300 553 315 for
assistance. Please ensure that you have the model number, serial number and purchase receipt ready when
you call.
Please complete the section below and keep this information for your own records.
Owner’s Name
Owner’s Address
Postcode
Model Name/No. Serial No.
Dealer’s Name
Dealer’s Address
Postcode
Authorised Service Centres in Major Australian Cities
NSW
151 Arthur Street
Homebush W est, NSW 2140
Queensland
Unit 1, 320 Curtin Ave West
Eagle Farm, QLD 4009
Western Australia
Unit 2, 50 Pilbara Street
Welshpool, WA 6106
South Australia
11 McInnes Street
Ridleyton, SA 5008
Victoria
282 Normanby Road
South Melbourne, VIC 3205
Thank you for selecting a TEAC product
.
If you should require assistance with your product regarding its setup
or operation, or if any difficulties arise, please call us directly for advice
between Monday to Friday at 8.30AM – 6PM AEST at the
TEAC Customer Support Hotline
1300 553 315
teacservicesupport@awa.com.au
www.teac.com.au
WARRANTY INFORMATION
v1.5.2: DEC 2011
Our goods come w ith g uarantees t hat cannot b e excluded und er t he Australian Consumer Law. You are
entitled t o a r eplacement or r efund f or a m ajor f ailure a nd f or c ompensation f or a ny ot her r easonably
foreseeable l oss or d amage. You are also e ntitled t o have t he goods repaired or replaced if the goods fail
to be of acceptable quality and the failure does not amount to a major failure.
Warranty Terms & Conditions
1. TEAC warrants that this product is free from defects in material and workmanship under normal domestic u se w ith
reasonable c are and s kill. Maintenance and c leaning ( i.e. l aser h ead) i s n ot c overed by this warranty. T he T EAC
warranty only applies to TEAC products purchased, used and serviced in Australia.
2. The benefits t o t he c onsumer given b y t his Warranty are i n addition t o other rights and r emedies of t he c onsumer
under a law in relation to goods or services to which the warranty relates, being the Australian Consumer Law.
3. Refund or replacement via your retailer is available for a period of 14 days after purchase for goods that have been
inspected and determined to have a major failure. Refund and exchange is not applicable for change of mind.
4. Subject to the t erms herein, this w arranty effectively c overs t he equipment as s pecified i n t he W arranty Periods
Table below from the date of purchase.
TEAC PRODUCT
WARRANTY PERIOD
LED/LCD TV 32” (80 cm) and above
1 Year (In-Home Service/ Pick up Available)*
All other TEAC products
1 Year (Carry-in Service)
5.
This service will only be provided as part of this warranty if all the following conditions are met;
In Home Service/Pick up* Service
a) The product is indicated in the Warranty Period Table.
b) The product is within the warranty period.
c) The product is located within the normal service area of the local TEAC Authorised Service Centre.
If TEAC determines that the product is not repairable on site, TEAC can complete the repair by taking the product to
a TEAC Authorised Service Centre.
Where In-Home service/Pick up* is not available, the purchaser is required to send the product to the nearest TEAC
Authorised Service Centre for repair. In this event, proof of purchase is required to support a warranty claim. After
the repair, the product will be available for collection b y or r eturn to t he p urchaser at a fee upon request. TEAC in-
home service can be made available at a fee upon request.
Carry-in Service
6. A 12-month replacement warranty is applicable to all Accessories such as Remote, Power Adaptors and Cables.
7. TEAC will ensure to the best of its abilities that all required parts are made available for any required service/repair.
8. TEAC Australia Pty Ltd and i ts Authorised Service C entres will u se t heir best endeavours t o c omplete p roduct
repairs w ithin a reasonable p eriod b ased on available resources an d w orkload du ring t he time w hen service is
requested and performed.
9. Refurbished p arts may b e us ed t o r epair the pr oduct. I n t he c ase of a r eplacement, the pr oduct may b e r eplaced,
with a refurbished unit of the same t ype or , if on e is unavailable, a similar refurbished m odel w ith equ al or b etter
features & specifications.
10. Please be advised that if the product presented for repair is capable of retaining user-generated data, the data may
be l ost during s ervicing. C ustomers are s trongly encouraged to back up all important information/data before
sending the product in for service/repair.
11. Service will b e pr ovided on ly dur ing n ormal business hours and under safety conditions an d circumstances. TEAC
and its authorised service agents can refuse any repair if safety, in relation to OH&S, becomes a concern to its staff
or authorised service agents’ personnel.
12. The warranty is void and warranty claims may be refused, subject to the Australian Consumer Law, if:
a) The product was not transported, installed, operated or maintained according to manufacturer instruction, or
b) The product was abused, damaged, tampered, altered or repaired by any unauthorised persons, or
c) Product failure is du e t o a ccidents dur ing us e, installation o r transit, p ower surges, u se of def ective o r
incompatible external devices, exposure to abnormal conditions such as excessive temperatures or humidity, or
entry of liquids, objects or creatures into the product.
13. No one is authorised to assume any liability on behalf of TEAC or impose any obligation on it, in connection with the
sale of any equipment other than as stated in this warranty and outlined above.
14. TEAC reserves the r ight to i nspect an d v erify w hether the pr oduct is ex hibiting a m ajor failure as claimed by
customers/retailers.
15. LCD dead pixel policy, please contact TEAC Customer Support Hotline on 1300 553 315 for assistance.
SAFETY PRECAUTIONS
CAUTION
The voltage supplied to the unit should match the voltage as printed on the AC
adapter. If you are in any doubt regarding this matter, consult an electrician.
Do not open the cabinet because this might result in damage to the circuitry or
electrical shock. If a foreign object should get into the unit, contact your dealer
or service company.
When removing the AC power plug from the wall socket, always pull directly on
the plug, never yank on the cord.
Placement of the device
Choose the installation location of your unit carefully. Avoid placing it in direct
sunlight or close to a source of heat. You should also avoid locations that are
subject to vibration, excessive heat, cold or moisture.
As the unit may become warm during operation, always leave sufficient space
around it for ventilation.
Do not place the unit on an amplifier, a receiver or any other device that
generates heat.
When the unit is turned on, if a TV is turned on nearby lines may appear on the
TV screen depending on the frequency of the broadcast. This is not a
malfunction of the unit or the TV. If you see such lines, move the unit and the
TV further apart.
Maintenance
If the surface of the unit gets dirty, wipe with a soft cloth or use a diluted mild liquid
soap. Allow the surface of the unit to dry completely before using.
For safety, disconnect the AC po
wer plug from the outlet before using.
Never spray liquid directly on this unit.
Do not use thinner and alcohol as they could damage the surface of this unit.
4
TABLE OF CONTENTS
1. DESCRIPTION
FUNCTION --------------------------------------------------------
Power Supply --------------------------------------------------------
-----------------------------------------------------
2. CONNECTIONS
Progressive scan video connect ---------------------------------------
3. IPOD/IPHONE OPERATION(REMOTE CONTROL ONLY)
Connecting to the AUX jack -----------------------------------------
Docking an iPhone/iPod
4. APPS OPERATION WITH IPHONE/IPOD
TROUBLESHOOTING
Download the apps ------------------------------------------------
5.
Troubleshooting ------------------------------------
6. SPECIFICATIONS
General -----------------------------------------------------
LIST OF MAIN PARTS
6
7
8
8
9
-------------------------------------------
-----
General function 10
10
11
12
5
Main unit & speaker box
Manual Remote controlContact card
CUSTOMER SUPPORT HOTLINE:
www.teac.com.au
1300553315
--------------------------------------------------------
General operation 9
---
--- ----------- ---
---
Speaker Dock
SR150iP
FUNCTION
6
1. DESCRIPTION
DESCRIPTION
iPod/iPhone operation TROUBLESHOOTING
CONNECTIONS SPECIFICATION
Apps operation with iPhone/iPod
VIDEO
Aux in button
switch to iPod mode.
connect to
- switch to Aux in mode.
POWER SUPPLY
Using AC Power
1 . Check if the power voltage, as shown on the type plate located on the back of the set,
corresponds to your local AC power supply. If it does not, consult your dealer or
service centre.
2 . Connect the power cord to the AC MAINS inlet and the wall outlet .
The power supply is now connected and ready for use.
3 . To switch off completely, unplug the power cord from the wall outlet.
• Unplug the power cord from the wall outlet to protect your set during heavy
thunderstorms.
• If the electric cable is damaged, it must be replaced by the manufacturer, or by the
qualification persons, in order to avoid danger.
7
DESCRIPTION
iPod/iPhone operation TROUBLESHOOTING
CONNECTIONS SPECIFICATION
Apps operation with iPhone/iPod
The remote control operates on one CR2025 battery (included).
To activate the remote control, remove the insulation tab inserted
in the battery
compartment.
When the operation of the remote
control becomes intermittent
or unsatisfactory,
replace the original
battery with a new 3-volt
lithium battery.
1.) Slide out the battery holder fr
om the remote control case.
2.)
Replace the 3V CR2025 battery. Be
sure the battery is installed
correctly.
The remote will not work if
the battery is installed with
the wrong polarity.
CAUTION: Danger of explosion if the battery
is replaced incorrectly.
Replace only with the same type battery.
3.) Insert the battery holder
back into the battery slot.
NOTE: Only use a well-known brand of cell battery to ensure the
longest life and best
performance.
8
iPod/iPhone operation TROUBLESHOOTING
CONNECTIONS SPECIFICATION
Apps operation with iPhone/iPod
2. CONNECTIONS
CONNECTING TO THE AUX JACK
COMPONENT VIDEO CONNECTION
Aux in button
the speaker to the TV.
audio
the speaker.
VIDEO
playback
use the TV controls to switch the TV's input source to
DOCKING AN IPHONE/IPOD
GENERAL OPERATION
ECO MODE (SAVE POWER)
9
iPod/iPhone operation TROUBLESHOOTING
SPECIFICATION
Apps operation with iPhone/iPod
3. IPOD/IPHONE OPERATION (REMOTE CONTROL ONLY)
4
4S
6
start up You should press the PL
Video
the volume
turn video playback output on/off.
the volume.
following
AY/PAUSE
button to play.
To save power, the unit will enter ECO Mode automatically when the stereo cable is not
plugged in, or if the docked Apple device has been on Standby for 15 minutes or fully
charged. The LED light will blink during ECO Mode.
10
TROUBLESHOOTING
SPECIFICATION
Apps operation with iPhone/iPod
4. APPS OPERATION WITH IPHONE/IPOD
GENERAL FUNCTION
DOWNLOAD THE APP
The unit can be operated via an app on the iPhone. The app can be downloaded from the
App Store.
When an iPhone is docked for the first time, a prompt will pop out. Select "YES" to go to the
App Store to download the app.
.
setting
to
Double-tap the main screen to show the Play menu and select desired tracks from there.
When an iPhone is docked for the first time, a prompt will pop out. Select "YES" to go to
the App Store to download the app.
separate
11
TROUBLESHOOTING
SPECIFICATION
5. TROUBLESHOOTING
TEAC Support at 1300 553 315.
wall power outlet is switched on.
another
void
12
SPECIFICATION
6. SPECIFICATION
GENERAL
Power supply
Power consumption
Power Consumption @ Standby
Power Output @ THD = 1%
Frequency Response @ +/- 1 dB
Sensitivity : L/R
Overload Source E.M.F.
Separation
S/N
Video output
Aux in jack
Net weight
Gross weight
Unit dimensions
Gift box dimensions
* Specifications are subject to change without notice
* Weight and dimensions are approximate
"Made for iPhone" and "Made for iPod" mean that an electronic accessory has
been designed to connect specifically to iPhone/iPod and have been certified
by the developer to meet Apple performance standards.
Apple is not responsible for the operation of this device or its compliance with
safety and regulatory standards.
iPhone, iPod, iPod classic, iPod nano, and iPod touch are trademarks of Apple
Inc., registered in the U.S. and other countries.
: AC 240V, 50Hz
: 140W
: < 0.5W
: 180W RMS (20W x 2 + 25W x 2 + 90W,
2.2.1 System)
: L/R ch (60Hz - 20kHz)
: 600mV
: > 2V
: > 50dB
: 60dB
: Component Video (Progressive Scan)
: 3.5mm
: 7.3kg
: 7.8kg
: 400 x 202 x 166 mm
: 445 x 262 x 215 mm
TEAC CUSTOMER SUPPORT HOTLINE (TCS)
1300 553 315
Between Monday to Friday – AEST 8.30AM to 6PM
-
1
-
2
-
3
-
4
-
5
-
6
-
7
-
8
-
9
-
10
-
11
-
12
-
13
