ToSee WARDEN 1 User manual

I have analyzed the provided installation instructions for the ToSee WARDEN 1 smart lock. The document outlines the step-by-step process of installing the lock, including adjusting the handle, installing the mortise and casing, linking the wire, and securing the screws. I'm ready to assist you with any questions you have about the installation process based on the information in this document.
What should I consider when adjusting the handle?

What is the adjustable range of the screw casing?

What does the arrow on the screw casing indicate?

www.toseesecurity.com.au

WARDEN 1 - INSTALLATION INSTRUCTIONS

www.toseesecurity.com.au

Installation

Adjusting the handle direction

Notice: Adjust the handle according to the direction you open the door.

www.toseesecurity.com.au

Features:

Step 1 Install Mortise Step 2 Install Sliding Screw Casing

Step 3 Install Back Panel and link wire Step 4 Install fixing screws

Step 5 installation complete

1.The screw casing

place is adjustable

from 55mm to

100mm far from the

square shaft.

Depending on the

location of the

hole-drilling or the old

door hole.

2.The arrow is

always pointing down

A installation template

in included with every

WARDEN 1