2. ITC
  3. 693RS-FF-KK-UML

ITC 693RS-FF-KK-UML User manual

  • Hello! I've reviewed the installation instructions for the ITC Push Lens Light model 693RS-FF-KK-UML. This document covers the necessary steps for installing the light, including marking, drilling, wiring, and sealing. I am ready to answer any questions you may have about the installation process or the light itself.
  • What should I do before starting installation?
    What is recommended for positive input?
    What should I use to prevent water ingress?
3030 Corporate Grove Dr.
Hudsonville, MI 49426
Phone: 616.396.1355
itc-us.com
For warranty information please visit www.itc-us.com/warranty-return-policy
DOC #: 710-00178 • Rev A •11/02/2022
1. Mark the corners and screw holes using the template
below and drill pilot holes. Cut out the surface.
PARTS/TOOLS NEEDED:
Push Lens Light Mounting Screws Power Drill
(Not Provided)
Marine Wire Connectors
(Not Provided)
Silicone Sealant
(Not Provided)
IMPORTANT SAFETY INSTRUCTIONS. READ CAREFULLY FOR YOUR PROTECTION AND SAVE ALL INSTRUCTIONS.
• Disconnect power before installing, adding or changing any component.
• To avoid a hazard to children, account for all parts and destroy all packing materials.
• It is recommended that fuse protection be added to the positive (+) input.
2. Wire the light following the wiring diagram below.
3. Attach light using the provided screws.1 Use silicone
sealant around the wires and screw holes to prevent any
ingress of water. Snap on decorative bezel.2
Cutting Template
INSTALLATION INSTRUCTIONS
Rectangular Push Lens
Courtesy Light
Part#: 693RS-FF-KK-UML
Page 1 of 1
Incoming
12V DC
Power
Red (+)Black (-)
Neutral (-)
Load (+)
Fuse
4.3”
0.75”
1
2
/