3030 Corporate Grove Dr.
Hudsonville, MI 49426
Phone: 616.396.1355
itc-us.com
1. Determine the installation location and mark
the clip locations. Drill pilot holes and screw in
the mounting clips using the provided screws.
2. Using the wiring diagram below, wire the light to
the units power.
General Considerations
• Disconnect power before installing, adding or changing any component.
• To avoid a hazard to children, account for all parts and destroy all packing materials.
• Do not install any luminaire assembly closer than 6” from any combustible materials.
• Max voltage: 12V DC ± 20%
• Operating temperature: -20° to 50°C
• Dimmable: 10% to 100%
• Product is designed for interior use only
3. Snap light into mounting clips.
Black (-)
12V DC (+)
Red (+)Black (-)
Incoming
12V DC
Power
Compel
PARTS/TOOLS NEEDED:
Compel Light Mounting Clips & Screws Butt Splice Connectors (Not
Provided) Power Drill
12.00
0.25
Hole Sized for #6 Screw
INSTALLATION INSTRUCTIONS
Compel™ Linear Light
Part#: 690471
For warranty information please visit www.itc-us.com/warranty-return-policy
DOC #: 710-00027 • Rev A • 06/27/17
Page 1 of 1
