2. BRExhaust
  3. 106-0507

BRExhaust 106-0507 User manual

  • I've reviewed the installation instructions for the BRExhaust 106-0507 Exhaust System. This document outlines the necessary steps for safely and correctly installing the exhaust system, including a detailed bill of materials and torque specifications. I'm ready to answer your questions regarding the installation process or any other aspects covered in the document.
  • What should be done before removing the old exhaust system?
    What is the recommended torque for tightening the clamps?
    What should be checked after 50 miles?
INSTALLATION INSTRUCTIONS | PART NO. 106-0507
BRExhaust — 1901 Corporate Ctr, Oceanside, CA 92056
Technical Support: 1-800-631-7271
When working on, under, or around any vehicle exercise cauon.
Please allow the vehicle's exhaust system to cool before removal, as
exhaust temperatures may cause severe burns. If working without a
li, always consult vehicle manual for correct liing specicaons.
Always wear safety glasses and ensure a safe work area. Serious injury
or death could occur if safety measures are not followed.
WARNING:
BRExhaust recommends
professional installaon
for all products
www.brexhaust.com
STEP 1:
(Carefully read all instrucons before installaon) Disconnect
the vehicle’s baery before removal of the OEM exhaust
system. This will prevent electrical accidents and will reset the
computer if it applies to the vehicle. Remove exisng exhaust
system from the vehicle. Only remove parts that will be
replaced. Clean exisng ange with a wire brush to ensure
proper sealing.
STEP 2:
Aach item 1/2 to exisng exhaust (nuts and bolts not
included)
STEP 3:
Connect item 4/5 to item 1/2 with item 3
STEP 4:
Connect item 6/7 to item 4/5 with item 3
STEP 5:
Connect item 8 to items 6/7 with item 3
STEP 6:
Connect item 9/10 to vehicle (hardware not included)
STEP 7:
For 1998 model, use item 11 in diagram, for all other years use
items 12 and 13
STEP 8:
Ensure new exhaust is not contacng any poron of the
underbody of the vehicle or drivetrain.
STEP 9:
Tighten all clamps starng from rear of the vehicle. (DO NOT
EXCEED 30FT-LB WHEN TIGHTENING CLAMP AND CHECK ALL
CLAMPS AFTER 50 MILES. RETIGHTEN IF NECESSARY)
BILL OF MATERIALS:
1. 168509
2. 168510
3. 167505
4. 171685
5. 171686
6. 171687
7. 171688
8. 171684
9. 103198
10. 103199
11. 103356
12. 103358
13. 103359
4
1
11
6
6
8
8
7 9
2 3 5
10
11
/