Wireless Remote Control
For Direct Damper Control
User Manual
Model WRC
Made in USA
MENU
SET
Introduction
The WRC can control airflow from 1024 different wireless
dampers installed on ceiling diffusers or registers. Each
damper is programmed from the WRC with a Zone number
from 1 to 32 and an Address from 1 to 32. Typically, a single
WRC would control up to 32 different diffusers or dampers with
the same Address. If more than 32 diffusers need to be
controlled in a single building, work spaces or floors in that
building could be assigned to differentAddresses and another
WRC used for that floor or work space.
The actuator/damper can be digitally set to any airflow from
0% (fully closed) to 100% (fully open) using the WRC. The
remote remembers the setting for each zone when the zone is
selected.
ZONE
AIRFLOW
%
SEL
ENT
Up and Down keys for setting the
Airflow level, Zone number or Address.
Displays the selected zone
or damper number.
Displays the percent
of maximum airflow.
SEL key is used to select the
Zone or Address number
or program the damper Zone
and Address.
ENT key is used to enter or
save the selected Airflow, Zone or
Address number and send
data to the damper.
26945 Cabot Road, Bldg #101 / Laguna Hills, CA 92653 / 949-916-0945 Fax 949-458-8502
www.eControlsUSA.com
eControls
Phone: (800) 435-
ALAN
(2526)
Fax: (877) 333-
ALAN
(2526)
Email: [email protected]
www.
ALAN
mfg.com
-
1
-
2
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Related papers
Other documents
-
Waves WRC-1 User manual
-
-
Tamiya TB-02 Owner's manual
-
-
ARRI WMU-1 User manual
-
-
-
-
-
Hilti DSW 2005-TS Operating instructions