Bin Rack
Assembly Instructions
Step 1:
Connect the upper posts and the lower posts with post connectors.
-The upper post is the longer one while
the lower post is the shorter one.
Step 3:
Nut x 16
Screw x 16
Hex key x 1
Long beam x 2
“U” shape beam x 2
Mini long beam x 14
Plastic cap x 4
Particle board x 1
Short beam x 4
Rail x 48
Upper post x 4
Lower post x 4
Post Connector x 4
Bin x 24
(Longer post)
(Shorter post)
Step 1:
Set up a "Rectangle" by assembling 2 posts with 2 short beams.
- One beam at the top & another at the bottom.
- Place the rivets into the posts.
- Tap to seat the rivets.
Finish the framework.
- Mount 2 "U" shape beams to the " Rectangle".
Front "U" shape beam heading up to mount to the #2
& #3 hole. Rear "U" heading down to mount to the #1 & #2 hole.
- Place 2 posts to the other ends of the "U" shape beams.
- Connect the 2 posts by placing 1 short beam at the bottom
& another at the top.
- Connect the 2
"Rectangle"s with 2 long beams at the top.
#2
#3
#2
#1
x 1 x16 x16 x 4
x 4
x 4
Step 5
Mount the rails to the mini beams accordingly.
Step 6
Put the bins on the rails.
Step 7:
Place the wooden board on the top.
And now, the system is ready for use.
Step 4:
Set up the layers.
- Add the mini long beams to the post in parallel, at the #7, #12,#17,
#22,#27,#32 & #37 hole from the top.
- Leaving the space of 4 holes each tier for the bins.
- Let the
"V" shape slot heading down
at the front while heading up at the back.
#7
#12
#17
#22
#27
#32
#37
Space
of
4 holes
#7
#12
#17
#22
#27
#32
#37
x 48
-
1
-
2
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Other documents
-
Edsal 1UGK8 Assembly Manual
-
Sandusky UR4416BIN36 Operating instructions
-
-
SafeRacks SR-4x4-W Pack24 Operating instructions
-
Stratco Outback® Gable Parallel Sunroof Installation guide
-
-
-
Husky MR481886W6B Operating instructions
-
Mendocino Forest Products 97773 Operating instructions
-
