1. Start by flipping over the laptop surface.
You should see a set of four holes.
2. Lay the support plate on top, making sure
to line up the holes on the plate to the holes
on the laptop surface.
3. Insert a washer into each of the four screw
hole beds, and then screw in each screw.
4. Next, we need to setup the tripod stand.
There are two knobs. Loosen knob (a) to raise
the height of the stand. Loosen knob (b) to
open up the tripod base. Tighten these knobs
when you have found the appropriate setting.
5. To attach the laptop surface to the tripod
stand, unscrew the knob on the support plate,
place on the tripod stand, and then tighten
the knob. You’re done!
