Page is loading ...
PLPTS1
Professional DJ Grade Laptop/Notebook Computer Rolling Stand
Construction Manual
Visit us online @
www.PyleAudio.com
Included parts:
8 x short screws
4 x long screws
4 x nuts
4 x adjustable clamps
4 x wheels
1 x I-bar
1 x T-bar
1 x main plate
1 x small plate
You will need a Phillips-head screwdriver to assemble your stand.
Constructing the PLPTS1.
1. Start by laying out the I-bar upside down, exposing a screw
hole at each corner:
2. Screw a wheel into each corner:
3. Screw the T-bar into the I-bar using the four long screws and
nuts:
4. Attach the adjustable clamps to the T-bar. Unscrew the clamp,
pop them onto the bar, and then screw the clamp back in.
5. Attach the main plate to the clamps on the longer end of the T-
bar and the small plate to the shorter end using the included short
screws.
6. You’re done! You can adjust the height of your stand using the
metal lock on the T-bar:
/
