Part No: Rev:
Page:
E.C.O. No:
CUSTOMER SERVICE PHONE: 1-800-426-8562
Paper m anagem ent com ponents m ay be either
suspended from the load bar or freestanding. The
horizontal until and vertical unit m ay be stacked if
desired.
Load B ar Installation
1. Tilt the load bar as show n and insert the top
hook located at each end into a panel slot (F ig .
1)
.
2. R otate the load bar dow n tow ard the panel.
3. M ove the load bar vertically dow nw ard to fully
engage the hoods into the panel slots. Verify
the hooks are engaged by pulling out at the
ends of the load bar (F ig . 2 ).
Tray Installation
These instructions apply to the 11" and 13"
horizontal unit and the 6" vertical unit.
1. Slide tray into paper m anagem ent fram e from
the front as show n until it m akes contact w ith
back of fram e (F ig . 3 ).
2. Lift back of tray up and over back support bar
of fram e (F ig . 4 ).
PANEL
SLO TS
FIG . 1
LO AD
BAR
FIG . 2
FIG . 3
FRO NT OF PAPER
MANAGEM ENT
FR AM E
TR AY
FIG . 4
BACK TRAY
SUPPORT BAR
TR AY
PAPER M ANAGEM ENT
(FOR PREM ISE, PLACES AND UNIGROUP PRODUCT)
In s ta lla tio n In s tr u c tio n s
214-127 1 of 2 7021-6764 D