3M ESPE™ Polycarbonate Crowns User guide

Category
Car kits
Type
User guide
TEMPORARY ANTERIOR CROWNS
Polycarbonate Crowns
3
4
1 of 2
1
2
Indications:
• Short-term or long-term provisional coverage
• Centrals, laterals, cuspids and bicuspids.
Crown Selection:
• Prepare tooth and determine crown size needed using 3M
ESPE
Mold-Guide provided in crown kit.
• Select appropriate crown and trial fit.
Crown Preparation:
• Seat crown on preparation. Mark
gingival contour using a pencil.
Remove crown and trim 1.0 mm below
line using a 3M
ESPE
Crown
Scissors, bur or stone.
• Cervical margins can be crimped, if
needed, using a 3M
ESPE
Crimping
Pliers. Reseat and check fit.
Crown Lining:
• Roughen inner crown surface with
diamond or bur to enhance adhesion of
an acrylic or resin lining material to
crown.
• Line crown with acrylic or resin
material to enhance fit and extend wear.
TEMPORARY ANTERIOR CROWNS
2 of 2
3M ESPE Customer Hotline 1-800-634-2249 70-2009-2461-4
Please refer to instructions for more detailed information 44-0019-9068-6
as well as precautionary and warranty information. © 2003 3M
3M, ESPE, and Sof-Lex are trademarks of 3M or 3M ESPE AG.
5
6
7
8
Polycarbonate Crowns
• Seat crown on moistened preparation.
Allow provisional material to set
according to manufacturer’s directions.
• Remove from mouth and trim to finish
line using a carbide bur. Smooth and
polish as required, using 3M
ESPE
Sof-Lex
Finishing and Polishing Discs
and rubber wheel.
Crown Cementation:
• Mix cement and fill crown, assuring
voids are not present in cement.
• Seat crown and allow cement to set.
Remove excess cement with scaler or
explorer. Floss interproximal areas.
1 / 1

3M ESPE™ Polycarbonate Crowns User guide

Category
Car kits
Type
User guide

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Ask the document