2. Oxford & Garden
  3. Siena Sofa

Oxford & Garden Siena Sofa, SIENA S76 Assembly Instructions

  • Hello, I've reviewed the assembly instructions for the Oxford & Garden Siena S76 sofa. This document provides a detailed step-by-step guide for assembling the sofa, along with a list of all required components and hardware. I am ready to answer your questions about the assembly process or any parts of the product description.
  • How many long bolts are included?
    How many short bolts are included?
    How many dowels are included?
15 Kingbrook Parkway, Suite 100 Simpsonville, KY 40067 p. 877.866.3331 f. 502.719.8888 oxfordgarden.com
Ver. 06.30.20
SIENA SOFA - S76
ASSEMBLY INSTRUCTIONS
COMPONENTS
HARDWARE
FINISHING ITEMS
Medium Grit Sandpaper
NOTE: If the furniture is going to be placed on a concrete or tile patio, it should first be rinsed well
to remove the sawdust that may cause some staining.
Back
Quantity: 1 Seat
Quantity: 1
4
3
Long Bolt
Quantity: 2
A
Quantity: 6
B
Guiding Bolt
Quantity: 1
C
E
Wood Screw
F
Quantity: 2 Quantity: 1
Allen Wrench
G
Dowels
Quantity: 4
D
Barrel Nut
Quantity: 8
Short Bolts
Ver. 06.30.20
INSTRUCTIONS
STEP 1 - Two Person Assembly Recommended
NOTE: This item uses tight tolerances, it is important to
follow the steps in the order shown here.
Lay leg assembly on flat surface and insert back
assembly .
STEP 2 -
See bottom notes on how to align barrel nuts and bolts.
Using the provided allen wrench and guiding bolt ,
secure TOP of the back with barrel nut and LONG bolt
as shown. Secure BOTTOM of the back as shown using
barrel nut and SHORT bolt .
NOTE: Do not tighten down in this step, leave loose until all
bolts are inserted, then tighten all bolts. Be certain not to
over tighten.
Ver. 2019.8.10
A
STEP 3
Next, insert the seat assembly into the rest of the
assembled parts.
STEP 4
Using the provided allen wrench and guiding bolt ,
secure seat with barrel nut and SHORT bolt as
shown.
STEP 5
Insert the remaining leg assembly into the assembled parts
and repeat steps 2 and 4 to secure. Next, further secure
the seat to the leg assemblies by driving two dowels
into the mortise holes as shown.
1
2
4
C
E
D
STEP 6
Lastly, go back and tighten all the bolts inserted previously
and insert two wood screws into the seat assembly as
shown.
F
B
How to align barrel nuts and bolts.
Insert a guiding bolt into the end of a barrel nut. Align the barrel nut inside of the component with the bolt used to
connect the components. Once the component bolt is aligned and threaded, simply pull the guiding bolt from
the end of the barrel nut.
1
4
1
4
A
D
B
D
2
C
DB
D
B
D
B
2
EF
F
/