WOOSIM Porti-P60/PP60 Operating instructions

Category
Label printers
Type
Operating instructions

This manual is also suitable for

http://www.woosim.com
MODEL PORTI-P
(2inch Panel Printer)
Rev 5.5
All specifications are subjected to change without notice
P Rev. 5.5
http://www.woosim.com
2018-07-11
2
All specifications are subjected to change without notice
Copyright
PORTI-P 2Inch Panel Printer Operator’s Manual.
Copyright ⓒ2017 by Woosim Systems Inc.
All rights reserved.
The information contained in this manual is the property of Woosim Systems Inc.
And may not be reproduced in whole or in part without the prior written permission of Woosim
System Inc.
Trademark
a registered trademark of Woosim Systems Inc.
All other trademark are the properties of their respective companies.
Caution
Some semiconductor devices are easily damaged by static electricity. You should turn the printer
“OFF”, before you connect or removed the cable on the rear side, in order to guard the printer
against the static electricity.
If the printer is damaged by the static electricity, you should turn the printer “OFF”
Notice
The contents of this manual are subject to change without notice.
P Rev. 5.5
http://www.woosim.com
2018-07-11
3
P Rev. 5.5
http://www.woosim.com
2018-07-11
4
Operating Precautions
Please follow the precautions below to enjoy and maintain the full performance of the
printer.
Using the Printer
Be careful not to drop or bump the printer on a hard surface.
Do not install the printer in direct sunlight or such areas.
Suitable environment for the use of the printer is as follows:
◆ Operating temperature :-10°C to 50°C
◆ Relative humidity : 30% to 85%
Do not install the printer near devices that generate strong electromagnetic fields
such as a copy machine.
Do not open the platen cover during printing .
Do not remove or reinstall the communication cable during printing or transmission.
Do not touch the connectors of the communication during printing.
Switch the POWER OFF when not in use.
Do not other solvent.
Thermal Paper Handling
Store the thermal paper in a cool, dry and dark place.
Do not rub the paper with hard object.
Do not leave the paper with hard object.
Do not allow plastic film, erasers, or adhesive tape to touch the paper for long periods.
Do not stack the thermal paper with diazo copies immediately after copying or wet-type copies.
Do not use chemical glue.
Always use the clean thermal paper.
P Rev. 5.5
http://www.woosim.com
2018-07-11
5
Note
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 the FCC Rules.
These limits are designed to provide reasonable protection against harmful
interference in a residential installation.
These equipment generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference to radio
communications.
However, there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception , which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
--Reorient or relocate the receiving antenna.
--Increase the separation between the equipment and receiver.
--Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
--Consult the dealer or an experienced radio/TV technician for help.
P Rev. 5.5
http://www.woosim.com
2018-07-11
6
CONTENTS
1. Outline ................................................................................................................................................................. 7
1.1. Model classifications ..................................................................................................................................... 7
1.2. Product Part Number System....................................................................................................................... 8
1.3. Specifications .................................................................................................................................................. 9
2. Setting up the printer ......................................................................................................................................11
2.1. Printer & Accessories ...................................................................................................................................11
2.2. Printer Features .............................................................................................................................................12
2.2.1. Part Name ................................................................................................................................................12
2.2.2. Dimension ................................................................................................................................................14
2.3. Installation .....................................................................................................................................................18
2.4. Replacing the paper roll ..............................................................................................................................22
2.5. Setting operation mode ...............................................................................................................................23
2.6. Power supply .................................................................................................................................................27
3. Interface ..............................................................................................................................................................28
3.1. Serial Interface (Porti-P30) ...........................................................................................................................28
3.2. Serial Interface (Porti-P40/60, P240) ...........................................................................................................29
3.3. Serial and Parallel Interface - (Porti-PP40/60, PP240) ..............................................................................30
3.4. Serial & USB Interface (Porti-PP40/60, PP240-RX Version) ..................................................................32
4. Using the printer ...............................................................................................................................................33
4.1. Control panel ................................................................................................................................................33
4.2. The self test ...................................................................................................................................................33
5. Consumable Parts .............................................................................................................................................34
5.1. Recommended paper ...................................................................................................................................34
5.2 Printing position ............................................................................................................................................34
6. Revision History ................................................................................................................................................35
P Rev. 5.5
http://www.woosim.com
2018-07-11
7
1
1
.
.
O
O
u
u
t
t
l
l
i
i
n
n
e
e
1.1. Model classifications
PORTIP ( ) ( ) ( )
Model name
Size of roll paper
30 : 57mm wide, 3
40 : 57mm wide, 40Ø
60 : 57mm wide, 60Ø
Interface
A0 : UART
C0 : USB(only PP40/60 RX)
Power
None : DC 9V
5V : DC 5V
12V : DC 12~24V (only PP40/60)
P Rev. 5.5
http://www.woosim.com
2018-07-11
8
1.2. Product Part Number System
Model name / Interface Spec.
Example) 1. Porti-S40 Serial/Bluetooth Part No. S40/A1
2. Porti-SC30 Bluetooth Only Part No. ⇒ SC30/Z1
Note) The above table is the interface format which is supported.
But some of the interfaces are not supported according to the product
and please contact us, if you have any questions regarding the interface.
S40
SC30
W25
.
.
.
Wired
Wireless
A
RS-232C
1
Bluetooth
B
TTL
2
IrDA
C
USB
0
None
D
RS-485
E
Parallel
Z
None
P Rev. 5.5
http://www.woosim.com
2018-07-11
9
1.3. Specifications
Item
Specification
Printing method
Direct thermal line printing
Characters per line
- Font A : 32cpl / Font B : 42cpl / Font C : 48cpl
- KOR, CHN, JPN : 16cpl
Character size
- Font Size A: 12X24 / Font Size B : 9X24 / Font Size C : 8X16
- KOR : 24X24(16X24) / CHN, JPN : 24X24
Optional Characters
Alphanumeric:95, Extended Graphics:128X31 pages, International:10,
Simplified/Traditional Chinese, Japanese, Korean
Resolution
203dpi, 8dots/mm
Print width
2-inch (48mm, 384dots)
Printing speed
50mm/sec (MAX)
Dimensions
(including PCB)
-P30
-P40,P240
-P60,PP60
-PP40,PP240
: 77.0 x 55.0 x 45.3 mm
: 80.0 x 75.0 x 44.0 mm
: 80.0 x 96.9 x 66.5 mm
: 80.0 x 75.0 x 63.0 mm
Weight
(w/o roll paper)
-P30
-P40,P240
-P60
-PP40
-PP60
: 78.5g
: 92.55g
: 125g
: 108g
: 136g
Interface
UART(RS-232C or TTL)
USB (only PP40/60 RX Version)
Paper supplied
Thermal roll paper (57mm wide - 30ø, 40ø, 60ø)
Barcode supplied
1-dimension : UPC-A, UPC-E, EAN-8, EAN-13, CODE-39, CODE-93,
CODE-128, ITF, CODABAR
2-dimension : PDF417, Micro PDF417, Truncated PDF417, QR-CODE,
DATA Matrix, Maxicode
Etc :GS1 databar
Driver
Microsoft Windows, Linux
H/W Spec
MCU : RX-32bit, RAM : 128M bit, FLASH : 64M bit
Receive buffer size
1M bytes
(Continue)
P Rev. 5.5
http://www.woosim.com
2018-07-11
10
Item
Specification
Input Power
5VDC±5%, Standby 60mA and 2.5A or more (P30,P40,P240)
7.5~8.5V (MAX 9VDC), Standby 60mA and 3A or more
(P30,P40,P60,P240)
12V~24VDC, Standby 60mA and 3A or more (PP40,PP60,PP240)
Environment
conditions
Temperature
-10°C ~50°C (operating)
-30°C ~ 7C (storage)
Humidity
30% - 80% (operating)
10% - 90% (storage)
MCBF (Mean Cycle
Between failure)
Mechanical
37,000,000 lines
Head
Approximately 50Km
< Table 1 >
P Rev. 5.5
http://www.woosim.com
2018-07-11
11
2
2
.
.
S
S
e
e
t
t
t
t
i
i
n
n
g
g
u
u
p
p
t
t
h
h
e
e
p
p
r
r
i
i
n
n
t
t
e
e
r
r
2.1. Printer & Accessories
When unpacking your printer box make sure it contains the printer and all accessories.
If any accessories are missing or damage, please contact your dealer for assistance.
Porti-P40,
PP40
Porti-P60,
PP60
Porti-P30
Porti-P240
Thermal roll paper
P Rev. 5.5
http://www.woosim.com
2018-07-11
12
2.2. Printer Features
2
2
.
.
2
2
.
.
1
1
.
.
P
P
a
a
r
r
t
t
N
N
a
a
m
m
e
e
1) PORTI-P30
2) PORTI-P40
P Rev. 5.5
http://www.woosim.com
2018-07-11
13
3) PORTI-P60
P Rev. 5.5
http://www.woosim.com
2018-07-11
14
2
2
.
.
2
2
.
.
2
2
.
.
D
D
i
i
m
m
e
e
n
n
s
s
i
i
o
o
n
n
1) PORTI-P30
[unit : mm]
2) PORTI-P40
P Rev. 5.5
http://www.woosim.com
2018-07-11
15
3) PORTI-P240
3) PORTI-P60
P Rev. 5.5
http://www.woosim.com
2018-07-11
16
4) PORTI-PP40
5) PORTI-PP60
P Rev. 5.5
http://www.woosim.com
2018-07-11
17
6) PORTI-PP240
P Rev. 5.5
http://www.woosim.com
2018-07-11
18
2.3. Installation
2.3.1 P30
2.3.2 P40
P Rev. 5.5
http://www.woosim.com
2018-07-11
19
2.3.3 P60
2.3.4 PP40
P Rev. 5.5
http://www.woosim.com
2018-07-11
20
2.3.5 PP60
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4
  • Page 5 5
  • Page 6 6
  • Page 7 7
  • Page 8 8
  • Page 9 9
  • Page 10 10
  • Page 11 11
  • Page 12 12
  • Page 13 13
  • Page 14 14
  • Page 15 15
  • Page 16 16
  • Page 17 17
  • Page 18 18
  • Page 19 19
  • Page 20 20
  • Page 21 21
  • Page 22 22
  • Page 23 23
  • Page 24 24
  • Page 25 25
  • Page 26 26
  • Page 27 27
  • Page 28 28
  • Page 29 29
  • Page 30 30
  • Page 31 31
  • Page 32 32
  • Page 33 33
  • Page 34 34
  • Page 35 35

WOOSIM Porti-P60/PP60 Operating instructions

Category
Label printers
Type
Operating instructions
This manual is also suitable for

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI