Levana Mila Quick start guide

Brand: Levana

Model: Mila

Category: Baby video monitors

Type: Quick start guide

Levana Mila is an advanced baby monitor with a large, high-resolution display, allowing you to keep an eye on your little one from anywhere in your home. With its two-way communication feature, you can talk and soothe your baby remotely, and the built-in lullabies can help them drift off to sleep. Mila also features a temperature sensor to ensure your baby's room is always at a comfortable level.

Mila Video Baby Monitor

Quick Start Guide

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device

may not cause harmful interference. (2) This device must accept any interference received, including interference that

may cause undesired operation.

IC STATEMENT / DÉCLA RATION IC:

This device contains license-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic Development Canada’s

license-exempt RSS(s). Operation is subject to the following two conditions: (1)This device may not cause interference.(2)This device

must accept any interference, including interference that may cause undesired operation of the device.

L’émetteur/récepteur exempt de licence contenu dans le présent appareil est conforme aux CNR d’Innovation, Sciences et Développe-

ment économique Canada applicables aux appareils radio exempts de licence. L’exploitation est autorisée aux deux conditions suivantes

:(1)L’appareil ne doit pas produire de brouillage; (2)L’appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est

susceptible d’en compromettre le fonctionnement.

This equipment complies with IC RSS-102 radiation exposure limits set forth for an uncontrolled environment. This equipment should be

installed and operated with minimum distance 20cm between the radiator and your body.

Cet équipement est conforme aux limites d’exposition aux radiations IC CNR-102 établies pour un environnement non contrôlé. Cet

équipement doit être installé et utilisé avec une distance minimale de 20 cm entre le radiateur et votre corps.

WARNING

Strangulation Hazard: Children can become entangled in cords.

Power cords should be kept at least 3ft away from the crib and

baby’s reach at all times. Failure to do so could be fatal. Baby

monitors/cameras with power cords should never be hung on

or near the crib.

Getting to Know Mila

Notication Bar

1. Signal Strength

2. Power Save Mode

3. Temperature Alerts (if activated)

4. Active Lullaby Playing

5. Monitor Audio Muted

6. Volume Level (at camera)

7. Temperature (at active camera)

8. Time

9. Battery Level

1 2 3 4 5 6 7 8 9

Getting to Know Mila

Buttons and Functions

Volume

Speaker

Wake Button

(Press & Hold for 3 sec. to Power ON/OFF)

Charging LED

Indicator

Navigation

Buttons

USB Charging

Port

Reset

Kickstand

Talk to Baby

™

Two-Way

Communication

(Press & Hold)

Menu & Conrm

Selection

Zoom/Back

(Press & Hold to switch the main

camera for PTZ and audio control)

Setting Up Your Mila Baby Monitor

Charge the Monitor for 7 hours and Plug in the Camera

Tabletop

7 hr

Wall Mount

Charged

Charging

IMPORTANT:

Ensure the camera’s temperature sensor is not

obstructed.

Power cords should be kept at least 3ft away

from the crib and baby’s reach at all times.

Setting Up Your Mila Baby Monitor

Adding/Pairing Additional Cameras

Press the Menu Button to

access the Device Menu.

Go to Settings. Then press the

Menu Button to select.

Go to Camera Pairing. Press the

Menu button to select.

Press and hold the Pair Button

on the bottom of the camera

until a beep is heard.

Pairing successful!Select a camera square with a

(+) icon to pair a new camera.

Using Your Mila Baby Monitor

Dierent Camera Views

Press the Menu Button, then press Camera View. Each mode will give you a dierent view:

Sequence Mode:

Cycles through each

camera view in full screen

Camera Select:

Select which camera

to view in full screen

Using Your Mila Baby Monitor

Using Lullabies

Press the Menu Button, then follow these steps:

NOTE: Camera Volume is set via this menu. This will also apply for the Talk To Baby™ function.

Menu Options

• Lullaby – Select the track you’d like to play on your camera.

• Voice Activation – Lullabies will turn on when the camera detects noises from your little one.

• Camera Volume – Sets the volume for all sound output from camera.

Using Your Mila Baby Monitor

Power Saving Modes

Press the Menu Button, then select Power Save. Each mode is unique and tailored to your needs.

*Approximate values, battery life depends on many factors like battery age, frequency of use/charging,

features you’ve activated, etc.

Sleep Mode turns on

your monitor only when your

baby makes a sound. After 20

sec. of silence, the screen will

turn o again.

In Audio Only, your

screen will turn o but you

will still hear your baby.

Always ON mode is

the default operation of

the monitor.

up to

hrs

up to

hrs

up to

hrs

Worry Less, Do More.

Our mission is to bring you the peace of mind you deserve during

your parenting journey. If your experience with your monitor is

anything short of amazing, we’re here to x that!

mylevana.com/videosmylevana.com/support mylevana.com/contact

/mylevana @mylevana /mylevana

Levana Mila Quick start guide

Brand: Levana

Model: Mila

Category: Baby video monitors

Type: Quick start guide

Download PDF

report

in other languages

français: Levana Mila Guide de démarrage rapide

Levana Mila Quick start guide

Levana Mila Quick start guide

in other languages

Related papers

Other documents