Place the base on a dry, level surface. Do not use on a tablecloth.
Pour appropriate amount of cool water into the base. Use measuring cup
provided: 40 ml (1.35 oz.) for up to 4 hot dogs, and 50 ml (1.7 oz.) for 5 or 6 h
dogs. You will see that the 40 ml amount of water completely fills up the lowest
level inside the Base, covering the stainless steel heater plate.
Place the cooking tray on the base. The lift “hook” goes towards the front.
Place hot dogs on the tray.
Up to four will fit if turned on angle on tray. For five
or six, place at cross angle on top. Then cover with lid.
Insert plug into a 120 volt electrical outlet. Power comes on as soon as plugged
in. The indicator light will glow, indicating power i
s on and the hot dogs are
It takes about 60 seconds for initial boiling to begin, which can be heard as it
starts. Then steam will start to build up. Steam will continue to boil away for six
to seven minutes for 40 ml of water, or 7 to 9 minutes
Once all the water has evaporated an internal thermostat controlling the heater
plate will cycle “OFF” and the appliance will audio signal with continuous
“barking”, telling you the hot dogs are heated. The indicator light will go ou
To stop the signal, unplug from outlet. This will disconnect from power. Don’t
leave plugged in as otherwise, thermostat in heater plate will cycle back “on”
Using tail as handle, lift off LID and place on nearby countertop. Usi
remove hot dogs directly from tray, serve and enjoy!
CAUTION: After cooking cycle is complete, BASE and COOKING TRAY will be
very hot, use caution when handing. COOKING TRAY will contain water and fats
from cooking and it is best to leave it in
When cooled, carefully lift out COOKING TRAY using lift handles (large “hook”
on front end, small “nub” on other end). Water and fat will be in the tray, so carry
it carefully and empty in sink.
g tray in warm soapy water, or in a dishwasher (cooking tray only).
Rinse thoroughly and dry. Let the base cool and wipe it with a damp cloth
NOT IMMERSE BASE IN WATER OR OTHER LIQUID. Place cooking tray and l
into the base. Power supply cord can be pushed into the base for storage.