Astria Fireplaces Envy Instruction Sheet

Brand: Astria Fireplaces

Model: Envy

Category: Fireplaces

Type: Instruction Sheet

This manual is also suitable for

Envy CD

NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE

P/N 506020-06

Rev. B 01/2014

INSTALLATION INSTRUCTIONS FOR ANDIRON KITS

FOR USE WITH ENVY AND ENVY CD DIRECT-VENT GAS FIREPLACES

FIREPLACE MODELS NV35IN, NVCD35IN, NV40IN, NVCD40IN, NV45IN AND NVCD45IN

DECORATIVE ANDIRON KIT

ENVY™ SERIES

HEARTH PRODUCTS

KITS AND ACCESSORIES

Envy™ Series Andiron Kits

Cat. No. Model Description

H8723 AKC-CLS-DLSCNV Andiron Kit, Classic

KIT CONTENTS

2 ea. Andirons

4 ea. Thumbscrews (2 attached to each andiron)

TOOLS NEEDED

Safety Glasses

Protective Work Gloves

Figure 1

GENERAL INFORMATION

This document contains installation instructions for the andiron kit used

with ENVY and ENVY CD direct vent gas ﬁreplaces. The decorative andiron

kit is offered as an enhancement to the ﬁrebox appearance.

If you encounter any problems, need clariﬁcation of these instructions

or are not qualiﬁed to properly install this kit, contact you local distribu-

tor or dealer.

Read this instruction sheet in its entirety before beginning the installation.

ALL WARNINGS AND PRECAUTIONS IN THE INSTALLATION INSTRUC-

TIONS AND CARE AND OPERATION MANUALS PROVIDED WITH THE

APPLIANCE APPLY TO THESE INSTRUCTIONS.

TURN OFF THE FIREPLACE AND ALLOW IT TO COMPLETELY COOL

BEFORE PROCEEDING.

FIREBOX ACCESS

Step 1. Use the ﬁreplace remote control to ensure the ﬁreplace is OFF.

Step 2. Remove the top louver.

Step 3. Remove the left and right side ﬁnish trim gap ﬁllers.

Step 4. Remove the surround trim assembly by detaching it at the top

of the ﬁreplace and lifting it 1” to disengage the side tabs, then

pulling it away from the ﬁreplace exposing the front glass door.

Step 5. Locate the four (4) spring-loaded latches (Figure 2); two above

and two below the enclosure. Release the lower latches, by

pulling each handle out and down to unhook it from the glass

door. Lightly press against the door, to hold it in position, while

releasing the two upper latches. Carefully grip the glass door at

both the top and bottom, and remove from the ﬁreplace. Retain

the door in a secure location for later reinstallation.

Upper Glass Enclosure Latches

Lower Glass Enclosure Latches

Figure 2 - Upper And Lower Glass Door Latches

NOTE: It is not necessary to handle the log set when installing the

andirons.

Lower Glass Enclosure Latches

Upper Glass Enclosure Latches

P/N 506020-06 Rev. B 01/2014

NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE.

IHP reserves the right to make changes at any time, without notice, in design, materials,

speciﬁcations, and prices, and to discontinue colors, styles, and products. Consult your local

distributor for ﬁreplace code information.

1508 Elm Hill Pike, Suite 108 • Nashville, TN 37210

INSTALLATION INSTRUCTIONS

The mounting holes for the andirons are located along the

front of the ﬁrebox.

NOTE: When installing the andirons for the ﬁrst time, use a

screwdriver to bend down the metal tabs covering the mounting

holes.

Step 1. Insert one of the andirons into the left mounting holes in the

ﬁrebox base (Figure 3).

Step 2. Insert the second andiron down into the right mounting holes

in the ﬁrebox base (Figure 3).

NOTE: The andirons are loose in their mounting holes to allow for

metal expansion when the ﬁreplace is in operation.

Figure 3 - Classic Andiron Installation

FIREPLACE REASSEMBLY

Step 1. Carefully position the glass door in front of the ﬁrebox and hook

the two upper spring-loaded latches over the door frame.

Step 2. Hook the two lower spring-loaded latches over the door frame.

Step 3. Use an ammonia-free glass cleaner and a soft, non-abrasive cloth

to remove ﬁngerprints and smudges from the glass door.

Step 4. Locate the surround trim assembly mounting slots along the

left and right edges of the ﬁrebox.

Step 5. Align the surround trim assembly with the mounting slots and

press in and down to lower it into position. Reinstall the left and

right side ﬁnish trim gap ﬁllers.

Step 6. Use an ammonia-free glass cleaner and a soft, non-abrasive

cloth to remove ﬁngerprints and smudges from the surround

trim assembly.

Astria Fireplaces Envy Instruction Sheet

Brand: Astria Fireplaces

Model: Envy

Category: Fireplaces

Type: Instruction Sheet

This manual is also suitable for

Envy CD

Download PDF

report

Astria Fireplaces Envy Instruction Sheet

This manual is also suitable for

Astria Fireplaces Envy Instruction Sheet

Related papers

Other documents