REQUIRED TOOLS AND SUPPLIES
1/8" Shims
Phillips Screwdriver
GENERAL INFORMATION
Bi-Fold glass doors are available in ebony, pewter and oiled bronze
fi nishes.
READ ALL THE STEPS BEFORE STARTING THE INSTALLATION
THE FIREPLACE MUST BE OFF AND COLD BEFORE BEGINNING.
ALL WARNINGS, PRECAUTIONS AND INSTRUCTIONS IN THE
INSTALLATION AND OPERATION MANUAL PROVIDED WITH THE
APPLIANCE APPLY TO THESE INSTRUCTIONS.
If you encounter any problems, need clarifi cation of these instructions
or are not qualifi ed to properly install this kit, contact you local
distributor or dealer.
If any of these parts are missing or damaged, contact your dealer or
IHP.us.com for referral information.
INSTALLING DOOR FRAMES
1. Remove screws from smoke shelf (see Figure 1).
2. Mount top door frame and secure with screws provided (see Figure 1).
3. Place bottom door frame on top of ash lip at front of fi replace (see
Figure 2).
4. Secure bottom door frame to brick with two hex screws provided as
shown in Figure 3 using a 7/16" open end or adjustable wrench.
Figure 1 - Installing Top Door Frame
Top Door
Frame
Smoke
Shelf
Figure 2 - Installing Bottom Door Frame
Hex Screw
Bottom Door
Frame
Ash Lip
Ash Lip
BDM SERIES GLASS BI-FOLD DOOR KITS
[FOR USE WITH MODELS: RAPTURE36/42/50, ORACLE36/42/50, GEORGIAN36/42/50, WRT6036/42/50, WRE6036/42/50, WRT6842/50]
GLASS DOOR KITS
36/42/50 FIREPLACES
P/N 127144-01
Rev. B, 03/2017
HEARTH PRODUCTS
KITS AND ACCESSORIES
127144-01B 1
IHP.us.com
KIT CONTENTS
1 ea. Glass Bi-Fold Doors
1 ea. Instruction Sheet
Cat. No. Model Description
F1011 BDMO36E 36" Mosaic Masonry Bi-Fold Door, Ebony
F1012 BDMO36G 36" Mosaic Masonry Bi-Fold Door, Pewter
F1013 BDMO36C 36" Mosaic Masonry Bi-Fold Door, Oiled Bronze
F1014 BDMO42E 42" Mosaic Masonry Bi-Fold Door, Ebony
F1015 BDMO42G 42" Mosaic Masonry Bi-Fold Door, Pewter
F1016 BDMO42C 42" Mosaic Masonry Bi-Fold Door, Oiled Bronze
F1020 BDMO50E 50" Mosaic Masonry Bi-Fold Door, Ebony
F1021 BDMO50G 50" Mosaic Masonry Bi-Fold Door, Pewter
F1022 BDMO50C 50" Mosaic Masonry Bi-Fold Door, Oiled Bronze
IHP.us.com 127144-01B2
NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE.
Printed in U.S.A. © 2014 Innovative Hearth Products
P/N 127144-01 Rev. B 03/2017
IHP reserves the right to make changes at any time, without notice, in design, materials, specifi ca-
tions, prices and also to discontinue colors, styles and products. Consult your local distributor
for fi replace code information.
1508 Elm Hill Pike, Suite 108 • Nashville, TN 37210
INSTALLING GLASS DOORS
Spring clips have been installed but minor adjustments may still be needed.
Install the doors using the following steps:
1. With bi-fold door completely folded, insert bottom pivot pin into hole
located at bottom corner of bottom door frame as shown in Figure 3.
2. Swing door to vertical position and make sure top pins slide into door
track. Door pin should snap onto the clip when vertical.
3. Repeat for other door.
DOOR ADJUSTMENT
Remove doors and slightly loosen upper spring clips. Replace and fully close
doors. Use 1/8" shims (any material) to level doors. Once proper setting is
achieved, carefully open doors enough to access pivot and spring clips with
a phillips head screwdriver. Tighten screws (see Figure 4).
Figure 3 - Installing Bi-Fold Doors
Spring Clip
Insert Pin into
Spring Clip
Pivot Hole
Insert Bottom
Pivot Pin into Hole
and Swing Door to
Vertical Position
Fold Door and
Slide Top Pins
Into Track
Partially
Opened
Doors
Side Front
Face Spring Clip
Figure 4 - Adjusting Door
-
1
-
2
Astria Fireplaces WRE68(PureFire) Instruction Sheet
- Type
- Instruction Sheet
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Related papers
Other documents
-
Superior Fireplaces WRE6000 Operating instructions
-
-
-
-
FMI BBM-42N-JHB User manual
-
-
FMI JM42SRA Owner's manual
-
-
-
Desa VGM42HR Owner's manual