Dakota Digital VHX-49F Installation guide

Manual # 650401A

VHX-49F

Dakota Digital VHX Instrument Installation

For 1949-‘50 Ford Car

Your new VHX-49F kit includes:

Installation

Control Box

CAT5 Cable

Universal Sender Pack

Installation Manuals

VHX Display

1. Remove the stock cluster from the dash and be sure to retain all hardware for reassembly.

Ford Adapter

Switch Assembly

Manual # 650401A

WARNING: This product can expose you to chemicals including lead, which is known to the State of

California to cause cancer and birth defects or other reproductive harm. For more information go to

www.P65Warnings.ca.gov

2. Remove the protective tape from the clear lens.

3. Connect the CAT5 cable to the system as the

VHX cluster is installed into the dash. Watch

carefully so you don’t scratch or damage the lens

or bezel, and take care when routing the CAT5

cable to the control box location.

4. Re-install the cluster into the vehicle using stock hardware and refer to

the main manual for wiring instructions to complete the VHX installation.