Dakota Digital VHX-37C Installation guide

Manual # 650436A

VHX-37C

Dakota Digital VHX Instrument Installation

For 1937-38 Chevrolet Car

Your new VHX-37C kit includes:

Installation

Control Box

CAT5 Cable

Universal Sender Pack

Installation Manuals

VHX Display

1. Remove the stock cluster from the dash and be sure to retain all hardware for reassembly.

Switch Assembly

Manual # 650436A

WARNING: This product can expose you to chemicals including lead, which is known to the State of

California to cause cancer and birth defects or other reproductive harm. For more information go to

www.P65Warnings.ca.gov

2. Connect the CAT5 cable to the system as the VHX cluster is installed into the dash.

Watch carefully so you don’t scratch or damage the lens or bezel, and take care when

routing the CAT5 cable to the control box location.

3. Re-install the cluster into the vehicle using the stock hardware on the (4)

four mounting tabs and refer to the main manual for wiring instructions to

complete the VHX installation.