MODEL: IM-101S
Instruction on Changing the Pump
1. Remove the two screws on the back of the unit. One of the screws is covered by
the label. (See IMG-01 to IMG-02).
2. Remove two screws at the bottom of the unit. (IMG-03).
3. Open the back and remove the six screws and the metal strip (IMG-04).
4. Locate the pump (IMG-05) and cut the white plastic strip and remove the screw
(IMG-06).
5. The pump is connected by two pipes. Cut the plastic strips. (IMG-07 & IMG-
08). Disconnect the two pipes from the pump and replace the pump. (IMG-09 &
IMG-10).
6. Reconnecting the pipes to the new pump is the most difficult step. Make sure that
the pipes are connected properly (IMG-07) so that water won’t leak out.
7. Slide the pump into its holding place (IMG-11) and put the unit back together.
<IMG-01> <IMG-02>
<IMG-03> <IMG-04>
<IMG-05> <IMG-06>
<IMG-07> <IMG-08>
<IMG-09> <IMG-010>
<IMG-011>
/