MODEL: SF-608R, SF-609
Instruction on checking the water curtain:
1. Remove the two screws from the
back of the unit near the top
(IMG-01).
<IMG-01>
2. Take off the back housing (IMG-
02).
<IMG-02>
3. Sometimes the water pipe
connected to the back housing is
bent too much and it affects the
water flow (IMG-03). You may cut
the pipe shorter and make the water
flow smoother. (IMG-04)
<IMG-03>
<IMG-04>
4. Next thing to check is the water
curtain. The whole upper edge of the
water curtain should be folded and
touching water in the reservoir (IMG-
05). If it’s not (IMG-06), follow the next
steps to adjust the water curtain.
<IMG-05>
Cut it shorter
Water reservoir
<IMG-06>
5. Remove the clips that hold the water
curtain (IMG-07).
<IMG-07>
Water curtain is not installed
properly.
6. Remove the screws that hold the
water curtain (IMG-08) and move the
curtain upward till the curtain touchs the
bottom of the water reservoir like IMG-
05. Reposition the screws and clips.
<IMG-08>
7. Reposition the back housing and the
screws. (IMG-09)
<IMG-09>
When putting the unit back together,
please make sure the white pipe on the
left goes back to the water tank and the
water curtain is not caught anywhere.
/