Attaching the slideway lining to the tabletop
Additional Instructions 911 - 00.0 - 04/2016 5
3 Attaching the slideway lining to the tabletop
Fig. 1: Attaching the slideway lining to the tabletop
To attach the slideway lining:
1. Remove the sliding plate (not shown).
2. Affix the double-sided adhesive tape on the underside of the slideway
lin
ing (2) and peel off the protective film from the tape (see
Appendix ( p. 6)).
3. Align the slideway lining (2) flush with the tabletop (1) and apply it.
4. Bond the inner insertion plate of the slideway lining (4) into the tabletop
cut-
out (3).
5. Reinsert the sliding plate.
6. Align the height of the machine head ( Service Instructions).
(1) - Tabletop
(2) - Slideway lining
(3) - Tabletop cut-out
(4) - Inner insert of the slideway lining