Danfoss 089F0656 Installation guide

Brand: Danfoss

Model: 089F0656

Type: Installation guide

This manual is also suitable for

089F0655

MAKING MODERN LIVING POSSIBLE

Installation Guide

Danfoss Air Flex Roof Hood

www.heating.danfoss.com

Danfoss A/S is not liable or bound by warranty if these

instructions are not adhered to during installation or service.

The English language is used for the original instructions.

Other languages are a translation of the original instructions.

(Directive 2006/42/EC)

1 Introduction

With a Danfoss Air Flex roof hood you do not have to worry about

tile types, roof pitch , etc. The flexible"skirt" makes it possible to

mount the hood on virtually all roof types (tar paper can be

burned on the flexible skirt).

The unique shape of the hood and the 2-split construction allows

adjustment from 0 to 50 degrees roof angle.

Note: Please check that the shipment is complete, and inspect that no

parts have been damaged.

2 Placement of Roof Hoods

The recommended placement of the roof hoods are:

▪

Horizontally: at least 3 m between inlet and outlet.

▪

Vertically: at least 1 m between inlet and outlet, with outlet

on top.

Furthermore, it is recommended to place the inlet roof hood on a

north or east facing flat for the best comfort in operation of the

system.

3 Mounting

When placement of the roof hoods have been decided, remove

the roof tile in that area.

Note: As shown in the picture, one tile must be adjusted, to ensure a

firm base for the skirt and for the next tile.

Secure an adequate hole size and that the flexible "skirt" has suffi-

cient overlap in order to provide for a watertight solution .

Installation Guide Danfoss Air Flex Roof Hood

Danfoss Heating Solutions VIGLA102

Remove the foil and fix the bottom part on the roof. Adapt the

flexible "skirt" to the roof, starting from the center out . Use a rub-

ber mallet or other soft tool .

Note: Before the foil is removed ,it is important to clean the roof thor-

oughly from dust, dirt, moss etc.

After the skirt is assembled , lay back the surrounding tile.

Place the top upright (90 degrees) and secure with the screws pro-

vided .

Note: The upper part can be turned 180 degrees, depending on which

angle you want.

Fully assembled Danfoss Air Flex roof hood.

Installation Guide Danfoss Air Flex Roof Hood

VIGLA102 Danfoss Heating Solutions

Installation Guide Danfoss Air Flex Roof Hood

Danfoss Heating Solutions VIGLA102

Installation Guide Danfoss Air Flex Roof Hood

VIGLA102 Danfoss Heating Solutions

Installation Guide Danfoss Air Flex Roof Hood

Danfoss Heating Solutions VIGLA102

Installation Guide Danfoss Air Flex Roof Hood

Danfoss A/S

Heating Solutions

Haarupvaenget 11

8600 Silkeborg

Denmark

Phone:+45 7488 8000

Fax: +45 7488 8100

Email: [email protected]

www.heating.danfoss.com

Danfoss can accept no responsibility for possible errors in catalogues, brochures and other printed material. Danfoss reserves the right to alter its products without notice. This also applies to products

already on order provided that such alterations can be made without subsequential changes being necessary in specifications already agreed. All trademarks in this material are property of the respective