Grace G40BTP Install Manual

Grace
Brand
Grace
Model
G40BTP
Type
Install Manual
1
Regulations
To ensure correct functionality and safety please read instructions
carefully before using this product. This luminaire complies with
AS/NZS 60598.2.1. All wiring and installation of this luminaire must
adhere to local and national wiring rules e.g. AS/NZS 3000:2007
Amendment 2:2012 Electrical Installation.
Tips
1. Always ensure power is off
and the tting has cooled
down before performing any
maintenance or adjustment to
the tting
2. To avoid injury or damage to
the tting, ensure that power
leads and screws are secure
before connecting the power
3. Handle the tting with care
to avoid breakage
4. Find a suitable location away
from liquids or hazards
5. To clean, wipe with a damp clean
cloth. Never soak the tting
with water.
Note: Please check tting label to
see if tting is dimmable and if so
which type of dimming.
Warning
1. Switch off power before
installation
2. Switch on only after complete
installation and examination of
the circuit
3. Only a qualied electrician can
install and maintain this tting
4. Product modication and/or
improper installation will
void warranty.
Surface Mounted Installation
Exterior
Batten
A. Mark 4 points with pencil on the surface of
ceiling/wall.
B. Drill 4 holes at the 4 marked points.
C. Insert one expansion stopper into each of the
4 holes.
D. Fix the 2 hooks into the ceiling/wall by 4 screws.
AB=CD, AC=BD
0.6m AC = 400mm
1.2m AC = 900mm
1.5m AC = 930mm
| Grace Exterior Batten – Install Manual novii.co.nz
IP65 IK10
2
| Grace Exterior Batten – Install Manual novii.co.nz
Surface Mounted Installation continued...
E. Push the luminaire to be xed by the 2 hooks.
Suspended Installation
A. Mark 2 points with pencil on the surface of
ceiling/wall.
B. Drill 2 holes at the 4 marked points.
C. Insert one expansion stopper into each of the
2 holes.
D. Insert the rope into the lock and screw them into
lock base
0.6m AB = 400mm
1.2m AB = 900mm
1.5m AB = 930mm
PUSH
3
| Grace Exterior Batten – Install Manual novii.co.nz
Suspended Installation continued...
E. Press the 2 hooks to x the luminaire. F. Fix the 2 hooks to x the ropes.
PUSH
Model
Dimensions
LxWxH mm
Power
(W)
CCT (K) IP Voltage (AC) Control
G40BTP 1270 x 85 x 95 40 3000, 4000, 5000 65 220-240V 50,60Hz Non-dim, 1-10V, DALI
G50BTP 1270 x 85 x 95 50 3000, 4000, 5000 65 220-240V 50,60Hz Non-dim, 1-10V, DALI
G60BTP 1570 x 85 x 95 60 3000, 4000, 5000 65 220-240V 50,60Hz Non-dim, 1-10V, DALI
  • Page 1 1
  • Page 2 2
  • Page 3 3

Grace G40BTP Install Manual

Grace
Brand
Grace
Model
G40BTP
Type
Install Manual
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents