eurotech lighting KARLIN4FTCCT User manual

Brand
eurotech lighting
Model
KARLIN4FTCCT
Type
User manual
1
3
1c 2
Karlin Batten
Model: KARLIN
Installation Instructions
For detailed specication, please go to our website eurotechlighting.co.nz
All installations must be carried out by a qualied electrician following local regulations. Make sure that the power is switched o before
installation. Please read and follow the ‘Installation Instructions’ and ‘Safety Instructions’ sections carefully before commencing installation.
Installation of this model can change from time to time. Please read instructions every time before installation. For detailed specication, please go to our website eurotechlighting.co.nz
Code: Dimensions (mm): Double
Insulated: IP Rating: Kelvins: Lumens: Material: Watts:
KARLIN4FTCCT 1200L x 60W x 65D Yes IP20 CCT - 3K / 4K / 6K 3960lm / 4500lm
/ 4140lm
Aluminium + Iron
+ PC 36W
Product Information
Installation Instructions
1. a. Slide both end caps out from base of tting. Note: End caps only slide out approximately 10mm from the base backplate.
b. Gently remove the lens module from the base of tting. Select the colour temperature.
c. Fix base of tting to ceiling / wall with supplied screws.
d. Wire the tting paying attention to live, neutral and earth markings.
2. a. Connect push lock terminal from the lens module, to the terminal on the base of the Batten tting.
b. Fit the lens module to the base and snap into place over the locating points.
3. Slide both end caps back into locked position to secure the lens module to the base of the tting.
4. LED & Fluorescent light ttings installed on the same circuit or phase are NOT compatible, and will void the warranty.
Please refer to the “switching capacity specications” of this tting when application is alongside technology such as sensors and dimmers.
Please refer to our website for more information (www.eurotechlighting.co.nz), or contact a Eurotech Lighting Consultant on: 09 818 6039
Product Visual
Safety Instructions
Read these instructions carefully before commencing installation.
1. The light source contained in this luminaire shall only be replaced by the manufacturer or this service agent
or a similar qualied person.
2. This LED luminaire must be installed by a licensed electrician ONLY following all local regulations.
3. Ensure that the cables will not be squeezed or damaged by sharp edges.
4. Clean the light with a soft cloth and a standard PH-neutral detergent.
5. Misuse of/or changes to the appliance shall void all warranties.
6. Do not install on a surface that is not suitable or deformed.
7. Do not install on or above a surface with a high temperature.
8. There should not be any materials that are corrosive, explosive.
  • Page 1 1

eurotech lighting KARLIN4FTCCT User manual

Brand
eurotech lighting
Model
KARLIN4FTCCT
Type
User manual
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents