GM Lighting 24VDC User manual

Brand: GM Lighting

Model: 24VDC

Type: User manual

GM Lighting 24VDC offers immense versatility for lighting needs, allowing both recessed and surface installations in various environments. It features a magnetically held trim for easy installation, eliminating the hassle of screws. With its low wattage consumption, it allows for multiple pucks to be connected in series. The pucks can be dimmed and operate in a wide range of temperatures, making them suitable for both indoor and outdoor use.

INSTALLATION INSTRUCTIONS

SLIM PUCK LED PUCK

“Lighting Enhanced by Design”

RECESSED INSTALLATION:

1. Determine the position of your puck(s) and trace a 2-1/4”

diameter circle on surface material. Using a keyhole saw or

2-1/4” (58mm) drill bit - cut through surface (Fig. 1).

2. Feed Puck wire through hole, and screw puck mounting

ring into surface using two screws

(supplied) (Fig. 2).

3. Connect feed wires to power supply and snap SlimPuck

Trim to SlimPuck. Trim is held magnetically. No need for

screws (Fig. 3).

SURFACE INSTALLATION:

1. Determine the position of your puck(s) and position

SlimPuck surface mount ring. Screw surface mount ring

onto surface (Fig. 4).

2. Making sure that you insert feed wire through SlimPuck

surface mount ring slot, position SlimPuck onto surface

mount ring. Ring is held magnetically. No need for screws

(Fig. 5).

3. Connect feed wires to power supply and snap SlimPuck

Trim to SlimPuck (Fig.3).

NOTE: Pucks can be mounted in series. Please observe

wattage limitations of power supply.

Example: A 20 watt power supply can power up to 8

2-watt Slim Pucks.

USE ONLY ELECTRONIC POWER SUPPLIES. DO NOT LOAD

POWER SUPPLY ABOVE 80% OF MAXIMUM.

BEFORE YOU START:

• Please check local electrical codes before beginning

• Turn power off before installing

• Make sure to use proper rated wire

“Lighting Enhanced by Design”

Speciﬁcations are subject to change

without notice.

18700 Ridgeland Ave. 150

Tinley Park, IL 60477

Toll-Free: (866) 671-0811

FAX: (708) 478-2640

www.gmlighting.net

[email protected]

TOOLS NEEDED:

• Keyhole Saw

• Phillips Screwdriver

SlimPuckInstallation_021122

SlimPuck

surface mount ring

SlimPuck with

48” lead

SlimPuck Trim

2-1/4” 48” - 24AWG leads included

Fig. 1

Fig. 2

Fig. 3

Wire Slot

Fig. 4

Wire Slot

Fig. 5

Electronic

Power Supply

GMSB-W/B

(splice box)

2 Watt 2 Watt 2 Watt 2 Watt 2 Watt = 10 Total Watts

2 Watt 2 Watt 2 Watt 2 Watt = 8 Total Watts

Electronic

Power Supply

NOTE: USE ELECTRONIC POWER SUPPLIES ONLY.

MAGNETIC POWER SUPPLIES ARE NOT

OPERABLE WITH THIS FIXTURE.

GM Lighting 24VDC User manual

GM Lighting 24VDC User manual

GM Lighting 24VDC User manual

Related papers

Other documents