INSTALLATION INSTRUCTIONS
SLIM PUCK LED PUCK
“Lighting Enhanced by Design”
®
RECESSED INSTALLATION:
1. Determine the position of your puck(s) and trace a 2-1/4”
diameter circle on surface material. Using a keyhole saw or
2-1/4” (58mm) drill bit - cut through surface (Fig. 1).
2. Feed Puck wire through hole, and screw puck mounting
ring into surface using two screws
(supplied) (Fig. 2).
3. Connect feed wires to power supply and snap SlimPuck
Trim to SlimPuck. Trim is held magnetically. No need for
screws (Fig. 3).
SURFACE INSTALLATION:
1. Determine the position of your puck(s) and position
SlimPuck surface mount ring. Screw surface mount ring
onto surface (Fig. 4).
2. Making sure that you insert feed wire through SlimPuck
surface mount ring slot, position SlimPuck onto surface
mount ring. Ring is held magnetically. No need for screws
(Fig. 5).
3. Connect feed wires to power supply and snap SlimPuck
Trim to SlimPuck (Fig.3).
NOTE: Pucks can be mounted in series. Please observe
wattage limitations of power supply.
Example: A 20 watt power supply can power up to 8
2-watt Slim Pucks.
USE ONLY ELECTRONIC POWER SUPPLIES. DO NOT LOAD
POWER SUPPLY ABOVE 80% OF MAXIMUM.
BEFORE YOU START:
• Please check local electrical codes before beginning
• Turn power off before installing
• Make sure to use proper rated wire
“Lighting Enhanced by Design”
®
©2022 GM Lighting
Specifications are subject to change
without notice.
18700 Ridgeland Ave. 150
Tinley Park, IL 60477
Toll-Free: (866) 671-0811
FAX: (708) 478-2640
www.gmlighting.net
TOOLS NEEDED:
• Keyhole Saw
• Phillips Screwdriver
SlimPuckInstallation_021122
SlimPuck
surface mount ring
SlimPuck with
48” lead
SlimPuck Trim
2-1/4” 48” - 24AWG leads included
Fig. 1
Fig. 2
Fig. 3
Fig. 4
Wire Slot
Fig. 5
Electronic
Power Supply
GMSB-W/B
(splice box)
+
-
2 Watt 2 Watt 2 Watt 2 Watt 2 Watt = 10 Total Watts
+
-
2 Watt 2 Watt 2 Watt 2 Watt = 8 Total Watts
Electronic
Power Supply
NOTE: USE ELECTRONIC POWER SUPPLIES ONLY.
MAGNETIC POWER SUPPLIES ARE NOT
OPERABLE WITH THIS FIXTURE.
