Page is loading ...
Tavlian Large Tray Table Floor Lamp
Item # KW 1900
ASSEMBLY INSTRUCTIONS
This light fixture should be installed in accordance with all applicable,
local installation codes, and by a person familiar with the construction
and operation of it, as well as the hazards involved. Inspect item and
contents carefully. If any damage or defect is found, do not install.
Retain all packaging material until installation is complete and approved.
NOTICE:
TOOLS REQUIRED (NOT INCLUDED):
A
C (Packaged separately)
D
E
E
H
K
H
K
L
L
J
I
I
G1
G2
F
Bulbs not included
Diagram 1
B
US
M
L
I
D
S
E
T
LED
1. Carefully remove all parts from the box. Place on a clean, soft surface.
NOTE: It is recommended to have a helper assist in supporting the
item for steps 2-4.
2. Install rod (E) to plate (H) and secure with plastic washer (K)
and screws (I). See diagram 1.
3. Connect quick connectors (G1) & (G2) together.
4. Install fixture body (J) to plate (H) and secure with screws (L). See
diagram 1.
5. Remove finial (B) from cluster (D).
6. Remove shade (C) from packaging and install to cluster (D) using
finial (B).
NOTE: If shade has additional packaging, carefully cut off from
interior of shade to avoid damages.
7. Install light bulbs into the sockets.
8. Place diffuser (A) onto the top of shade (C).
9. Remove protective cover (F) from plug.
10. Plug into electrical outlet and test the fixture.
Care Instructions: Clean only with a soft dry cloth or feather duster. Do
not use abrasive or chemical agents.
-
W
+
B
BW
+-
B W
+ -
B
W
+-
Phillips Screwdriver Slotted Screwdriver Scissors
PERSONS REQUIRED: Two
/
