VISUAL COMFORT TOB3023 User manual

  • I've reviewed the assembly instructions for the Large Terri Round Table Lamp, model TOB3023. This guide covers unpacking, installing the light bulb and shade, and the initial testing of the fixture. I'm ready to address any questions you might have regarding the assembly process or basic maintenance.
  • What tools are required for assembly?
    What should I do if I find damage or a defect?
    How should I clean the lamp?
Large Terri Round Table Lamp
Item # TOB3023
ASSEMBLY INSTRUCTIONS
ALB Version
This light fixture should be installed in accordance with all applicable,
local installation codes, and by a person familiar with the construction
and operation of it, as well as the hazards involved. Inspect item and
contents carefully. If any damage or defect is found, do not install.
Retain all packaging material until installation is complete and approved.
NOTICE:
A
Bulb not included
B
TOOLS REQUIRED (NOT INCLUDED):
Scissors
US
M
L
I
D
S
E
T
1. Carefully remove all parts from the box. Place on a clean, soft surface.
2. Install light bulb into the socket.
3. Remove shade (A) from packaging and clip onto light bulb.
NOTE: If shade has additional packaging, carefully cut off from
interior of shade to avoid damages.
4. Remove protective cover (B) from plug.
5. Plug into electrical outlet and test the fixture.
Care Instructions: Clean only with a soft dry cloth or feather duster. Do
not use abrasive or chemical agents.
Large Terri Round Table Lamp
Item # TOB3023
ASSEMBLY INSTRUCTIONS
CG Version
This light fixture should be installed in accordance with all applicable,
local installation codes, and by a person familiar with the construction
and operation of it, as well as the hazards involved. Inspect item and
contents carefully. If any damage or defect is found, do not install.
Retain all packaging material until installation is complete and approved.
NOTICE:
A
Bulb not included
TOOLS REQUIRED (NOT INCLUDED):
Scissors
US
M
L
I
D
S
E
T
B
1. Carefully remove all parts from the box. Place on a clean, soft surface.
2. Install light bulb into the socket.
3. Remove shade (A) from packaging and clip onto light bulb.
NOTE: If shade has additional packaging, carefully cut off from
interior of shade to avoid damages.
4. Remove protective cover (B) from plug.
5. Plug into electrical outlet and test the fixture.
Care Instructions: Clean only with a soft dry cloth or feather duster. Do
not use abrasive or chemical agents.
/