2. Crystorama
  3. 2245-BF
2245-BF

Crystorama 2245-BF User manual

  • Hello! I'm a chat assistant and I've read through the assembly instruction for the CRYSTRAMA 2245-BF lighting fixture. This document describes how to assemble the fixture, including steps for connecting iron tubes, securing the rings, and installing the light cluster and fabric shades. I am here to answer your questions about this product.
  • What type of bulbs are needed for the fixture?
    What is the recommended wattage for bulbs used in the fixture?
    Is this fixture suitable for damp locations?
ASSEMBLYINSTRUCTIONMODEL#2245-BF
CRYST
RAMA
WARNING:
ElectricalDanger TurnPoweroff
WARNING: ThisproductcanexposeyoutoLead
whichisknowntothestateofCaliforniatocausecancer
and/orbirthdefectsorreproductiveharm.Formore
informationgotowww.P65Warnings.ca.gov
L I G H T I N GT H EW A YF O RS I X T YY E A R S
installedbyalicensedelectrician
inaccordancewiththeNational
Allelectricalcomponentsmustbe
ElectricCodeandtheappropriate
localelectricalcodes.
Howtoinstall
9.Installthebulbs(notincluded)intothesocket.
Youwillneed -CandelabraBaseBulb4
40WattsRecommended60WattsMax.
USELEDBULBSFOREXTENDEDUSE
This fixture is Dry rated
3.Slipthecenterrodalongwireandthreadintothe
couplinglocatedonthetopofthelightcluster.
Makesurethattheirontubesareassembledstraight
relativetothetopandbottomringbeforetightening
thetopscrewsandthebottomfinials.
5.Spreadthearmssothatthearmsareatequal
distancefromeachother.
8.Installthefabricshadeontothecandlesleeve.
4.Slipthearmassemblyalongwireandthreadinto
thecenterrod.
7.Sliptheloopalongwireandthreadontothenipple
ofarmassembly.
ARMS
CHAIN
LOOP
NIPPLE
SHORTSCREWS
(Theshortscrewsfromtopsquarering)
(Thelongscrewsfromirontubes)
LONGSCREWS
TOP SQUARERING
FABRIC SHADE
IRONTUBES
CANDLESLEEVE
CENTER
ROD
BOTTOM
SQUARERING
BOTTOMFINIALS
LIGHTCLUSTER
COUPLING
6’’
3/4’’
21’’
16’’
95’’
FABRIC
SHADE
4’’
5-1/2’’
4-1/2’’
1.Placethethreadedendofairontubeintoaholeon
thebottomsquarering.Securewithafinial.Repeat
thisfortheotherirontubes.
2.Removethelongscrewfromeachoftheirontubes.
Aligntheholesonthetopsquareringwiththeholes
thatthelongscrewswereremovedfrom.Tighten
eachscrewintotheholestosecurethetopsquare
ringandthe(4)irontubestogether.
6.Removetheshortscrewfromeachoftheholeson
thetopsquarering.Aligntheholesonthetabsof
thearmassemblywiththeholesonthetopsquare
ringandsecuretogetherusingtheshortscrews
thatwereremoved.
CRYST
RAMA
L I G H T I N GT H EW A YF O RS I X T YY E A R S
PartNumber
PartNumbers
A.(1)-Mountinghardware
B.(1)-CanopyW6’’xW6’’xH3/4’’ #XRF2240BFCAN6IN
J.(1)-TopsquareringW13-5/8’’xW13-5/8’’xH1/2’’ #XRF2245BFTOPRING
I.(4)-Longscrew
C.(1)-Collarring
H.(8)-Shortscrew
ASSEMBLYINSTRUCTIONMODEL#2245-BF
N.(4)-FabricshadeW4-1/2’’xH5-1/2’’ #XRF2245BFSHA5.5IN
O(A).(4)-Candlesleeve-BFW7/8’’xL3-3/8’’ #XRF2241BFCDL3.3IN
A
B
CD
E
F
H
I
J
K
L
M
N
O
D.(1)-Collarloop
E.(1)-Chain-72’’,4mmthick#XRF2240BFCHA4.0MM
F.(1)-Loop#XRF2240BFLOOP
G.(1)-PipeD1/2’’x4-3/8’’
K.(4)-IrontubeL12-3/4’’xH1/2’’ #XRF2245BFIRT
L.(1)-BottomsquareringW15-3/4’’xW15-3/4’’xH1/2’’ #XRF2245BFBOTRING
M.(4)-Bottomfinial#XRF2243BFFIN
O(B).(4)-Candlesleeve-WHW7/8’’xL3-3/8’’ #XRF2241WHCDL3.3IN
/