Allied Brass 420G-SN Installation guide

Cap

Robe Hook

Backplate

Screw

0.7

Step 1:

Determine your desired location for installation and make a mark for the location . Make 2 marks where mounting screws will

be placed as shown below. Mark for location of installation.Drill hole at each end of the marks.

Drill holes in Wall for Backplate Mounting

Attach Robe Hook to Backplate

Step 2:

Unscrew Cap.Then mount Backplate to desired location and screw them in placed.Then insert Robe Hook into Backplate and

screw Cap.

420G

INSTALLATION INSTRUCTIONS

No portion of this document or any artwork contained herein should reproduced in any way without the written conset of ALLIED BRASS INC.

This manual is also suitable for

Download PDF