Allied Brass 426D-UNL Installation guide

426D-UNL
Allied Brass
Brand
Allied Brass
Model
426D-UNL
Type
Installation guide
Cap
Tumbler /Toothbrush
Holder
Backplate
Screw
0.7
Step 1:
Determine your desired location for installation and make a mark for the location . Make 2 marks where mounting screws will
be placed as shown below. Mark for location of installation.Drill hole at each end of the marks.
Drill holes in Wall for Backplate Mounting
Attach
Tumbler /Toothbrush Holder
to Backplate
Step 2:
Unscrew Cap.Then mount Backplate to desired location and screw them in placed.Then insert Tumbler/Toothbrush Holder
into Backplate and screw Cap.
426G
INSTALLATION INSTRUCTIONS
No portion of this document or any artwork contained herein should reproduced in any way without the written conset of ALLIED BRASS INC.
  • Page 1 1

Allied Brass 426D-UNL Installation guide

426D-UNL
Allied Brass
Brand
Allied Brass
Model
426D-UNL
Type
Installation guide
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents