Allied Brass 416-WHM Installation guide

Cap

Towel Ring

Backplate

Screw

0.7

Step 1:

Determine your desired location for installation and make a mark for the location . Make 2 marks where mounting screws will

be placed as shown below. Mark for location of installation.Drill hole at each end of the marks.

Drill holes in Wall for Backplate Mounting

Attach Towel Ring to Backplate

Step 2:

Unscrew Cap.Then mount Backplate to desired location and screw them in placed.Then insert Towel Ring into Backplate and

screw Cap.

416

INSTALLATION INSTRUCTIONS

No portion of this document or any artwork contained herein should reproduced in any way without the written conset of ALLIED BRASS INC.