2. Computers & electronics
  3. Computer components
  4. Chassis components
  5. Mounting kits
  6. Gamber-Johnson
  7. Tall Computer Platform

Gamber-Johnson Tall Computer Platform, 7160-0398 Specification

  • Hello! I am an AI chatbot trained to assist you with the Gamber-Johnson Tall Computer Platform Specification. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
INSTALLATION INSTRUCTIONS
Product Revision Form #
If you need assistance or have questions, call Gamber-Johnson at 1-800-456-6868
Product Mounting Disclaimer
Gamber-Johnson is not liable under any theory of contract or tort law for any loss, damage, personal injury, special, incidental or consequential damages for personal injury or other damage
of any nature arising directly or indirectly as a result of the improper installation or use of its products in vehicle or any other application. In order to safely install and use Gamber-Johnson
products full consideration of vehicle occupants, vehicle systems (i.e., the location of fuel lines, brakes lines, electrical, drive train or other systems), air-bags and other safety equipment is
required. Gamber-Johnson specifically disclaims any responsibility for the improper use or installation of its products not consistent with the original vehicle manufactures specifications
and recommendations, Gamber-Johnson product instruction sheets, or workmanship standards as endorsed through the Gamber-Johnson Certified Installer Program.
© copyright 2011 Gamber-Johnson, LLC
Computer Mount Brackets
7160-0398 (2.3" High)
7160-0311 (4.5" High)
A
INST-554
Computer Mount Brackets are used to mount a dock or cradle to a flat surface.
The 7160-0398 Computer Mount Bracket places the dock/cradle 2.3" above the surface.
The 7160-0311 Computer Mount Bracket places the dock/cradle 4.5" above the surface.
Position the Computer Mount Bracket on the flat surface in the desired location.
Mark the locations of the (4) square holes on the surface. Drill a 9/32" hole in each
location that you just marked.
Fasten the Computer Mount Bracket to the dock or cradle with the (4) 1/4-20unc x 1/2"
long socket button head screws that are provided with the dock or cradle.
Place the assembled unit on the flat surface and attach with the (4) 1/4-20 x 3/4"
carriage bolts, washers, and lock nuts that are provided in hardware bag 7120-0216.
© copyright 2011 Gamber-Johnson, LLC
PS-001
Dock or Cradle
Flat Surface
Computer Mounting Bracket
(4) .25-20 x 1/2"
Button Head Screws
(4) .25-20 x 3/4"
Carriage Bolts, Washers & Nylok Nuts
Drill (4) 9/32" (.281) diameter holes
/