Mayser Miniature Safety Edges Quick start guide

Brand: Mayser

Model: Miniature Safety Edges

Type: Quick start guide

Mayser Polymer Electric Postfach 30 48 89020 Ulm Germany Tel. +49 731 2061-0 Fax +49 731 2061-222

Fixing Instruc

tions

for Miniature Safety

Edges

300707 v1.1

1/1

Liner

Acrylic Foam

EKS

Fixing the Miniature Safety Edge EKS

coated with acrylic foam

Requirements

For ideal bonding, the bonding surface must be

+ clean

+ dry

+ smooth.

Avoid

- very uneven

- sharp-edged bonding surfaces.

Note: check with adhesion tests before serial use whether bonding is possible

on the selected installation surface.

1. Clean and degrease bonding surface.

2. Apply primer to complete bonding surface with brush.

Note: ideal results are achieved with the primer 4297 from 3M.

3. Air dry primer for approx.10 minutes.

4. Remove liner of acrylic foam 10 to 15 cm.

5. Place on bonding surface and press down well.

6. Repeat points 4 and 5 until EKS is completely bonded.

7. Maximum adhesion is achieved after 24 hrs.

Bonding

Bonded on: with primer without primer

ABS + -

Aluminium + +

Aluminium, anodised + -

CAB - -

Wood: untreated - -

Wood: varnished, veneered or

plastic-coated + -

PA6 + -

PA66 + +

PE, HDPE - -

PMMA + +

PP + -

PS - -

PVC + +

SAN + -

Steel, stainless steel + +

With/without primer

1

Mayser Miniature Safety Edges Quick start guide

Brand: Mayser

Model: Miniature Safety Edges

Type: Quick start guide

Related papers

Other documents