Mayser SE 1 TPE Quick start guide

Brand
Mayser
Model
SE 1 TPE
Type
Quick start guide
Mayser Polymer Electric Postfach 30 48 89020 Ulm GERMANY Tel. +49 731 2061-0 Fax +49 731 2061-222
Assembly Instruc-
tions SE 1 TPE
Spring contact
A complete Safety Element SE 1 TPE
in 5 easy steps
230412 v1.3 / TNr. 7501801
Page 1/2
1. Cut contact tube
2. Assembly
3. Position end cap
and sealing ring
contact tube inside of end
cap
2a 2b
sealing ring (oval)
sealing ring (round)
• The contact tube (KS) is always
shorter than the nished Safety Edge
(SL). Measure out required length of
contact tube and mark accordingly.
L
KS
= L
SL
- 14 mm -X
whereby: L
KS
= length of contact tube
L
SL
= length of Safety Edge
cable axial: X = 21 mm
cable 90°: X = 29 mm
• Cut to the required length making
sure that the cut edge is straight.
Insert the spring contact PCB into the contact tube as far as the stop position.
• Place and position end cap on the
contact tube end. Ensure that the
curvature of the end cap coincides
with the tube curvature (see picture
on left).
Tip: Make a mark 9 mm from the end
of the contact tube. The end cap must
completely cover this mark.
• Position sealing ring (oval) until it is
ush with the end cap.
• On the cable end also position the
sealing ring (round) in the middle.
These instructions describe cutting of the contact tube to the required length and tting of the end cap on
the resistance side. Fitting is identical on the cable side – apart from the additional sealing ring (round) for
the cable seal.
Mayser Polymer Electric Postfach 30 48 89020 Ulm GERMANY Tel. +49 731 2061-0 Fax +49 731 2061-222
230412 v1.3 / TNr. 7501801
Page 2/2
4. Close tool
5. Position and test
Prior to closing the tool, ensure that the
contact tube, end cap and sealing ring
are correctly positioned!
If
• the contact tube and end cap are on
the same horizontal
and
• the contact tube and end cap are on
the same vertical line,
then
• close the tool around the sealing ring
(oval). In addition, use the tool on the
the sealing ring (round) at the cable
end – for direction, see picture.
• Connect up the SE 1 TPE and test for
function.
• Carefully position the complete Safety
Element in the rubber prole of the Safety
Edge.
Tip: The cable pulling device Kati
®
Blitz is
suitable for aiding insertion of the Safety
Element in the rubber prole.
The Safety Element may be irreparably damaged!
Ä Max. permissible pulling force on cable: 30 N
Ä No pressure may be exerted on the contact tube in non-operative mode.
• If necessary, seal both rubber prole ends.
Tip: See "Assembly Instructions for Safety Edges" for the next assembly process.
  • Page 1 1
  • Page 2 2

Mayser SE 1 TPE Quick start guide

Brand
Mayser
Model
SE 1 TPE
Type
Quick start guide
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents