SWM-2
SPECIFICATIONS
Power: The SWM-2 is rated at 100 Watts RMS continuous.
Size: The SWM-2 will fit most standard single electrical junction
boxes.
Connections: Screw type connectors.
GENERAL INFORMATION
The SWM-2 switches up to two pairs of speakers, in any combination. from one
convenient location. The wiring diagram illustrates connections to the SWM-2. Note that
all the LEFT speaker and LEFT amplifier connections are on one side of the unit, and all
the right ones are on the other. Wires should be stripped about 1/4", inserted in the
appropriate connector opening, and the screw tightened. Check to be sure that no stray
strands stick out to cause short circuits!
WARRANTY
Your AUDIOPLEX TECHNOLOGY SWM-2 speaker selector is covered by a
LIFETIME warranty against any defects in workmanship and materials. Any defects will
be remedied without charge for labor or parts.
Damage incurred by shipping or by accident is not considered to be a defect, and
not covered by this warranty. AUDIOPLEX TECHNOLOGY is not responsible for
defective operation caused by abuse or by modification or service by any unauthorized
person or agency.
The unit must be properly installed and operated according to instructions for the
warranty to apply. Any necessary servicing must be done by AUDIOPLEX TECHNOLOGY.
The product must be returned expenses prepaid, with written authorization from the
company. The product must be shipped with the proof of purchase and in the original
carton and packing material to avoid damage.
This warranty gives you specific legal rights. You may have other rights which vary
from state to state.
TECHNOLOGY
INSTALLATION MANUAL
IN-WALL STEREO SWITCHER
2000 - 6/22/00
AUDIOPLEX TECHNOLOGY
404 GWH P.O. BOX 440
MELVIN VILLAGE, N.H. 03850
1-800-257-2077 IN N.H. 1-603-544-8601
FAX: 1-603-544-8901
E-MAIL: [email protected]
AMPLIFIER
OUTPUTS
+ L - - R +
- L +
- R +
SWM-2
(FRONT VIEW)
+ R -
+ L -
WIRING DIAGRAM
SMW-2
L+ L- R- R+
OUTPUT
L+ L- R- R+
OUTPUT
L+ L- R- R+
INPUT
2000 - 6/22/00
INSTALLING THE SWM-4
SPECIFICATIONS
Power: The SWM-4 is rated at 100 Watts RMS continuous.
Size: The SWM-4 will fit most standard single electrical junction
boxes.
Connections: Screw type connectors.
GENERAL INFORMATION
The SWM-4 switches up to four pairs of speakers, in any combination, from one
convenient location. The wiring diagram illustrates connections to the SWM-4. Note that
all LEFT speaker and LEFT amplifier connections are on one side of the unit, and all the
right ones are on the other side. Wires should be stripped about 1/4", inserted in the
appropriate connector opening, and the screw tightened. Check to be sure that no stray
strands stick out to cause short circuits!
WARRANTY
Your AUDIOPLEX TECHNOLOGY SWM-4 speaker selector is covered by a
LIFETIME warranty against any defects in workmanship and materials. Any defects will
be remedied without charge for labor or parts.
Damage incurred by shipping or by accident is not considered to be a defect, and
not covered by this warranty. AUDIOPLEX TECHNOLOGY is not responsible for
defective operation caused by modification or service by any unauthorized person or
agency.
The unit must be properly installed and operated according to instructions for the
warranty to apply. Any necessary servicing must be done by AUDIOPLEX TECHNOLOGY.
The product must be returned expenses prepaid, with written authorization from the
company. The product must be shipped with the proof of purchase and in the original
carton and packing material to avoid damage.
This warranty gives you specific legal rights. You may have other rights which vary
from state to state.
TECHNOLOGY
INSTALLATION MANUAL
2000 - 6/22/00
AUDIOPLEX TECHNOLOGY
404 GWH P.O. BOX 440
MELVIN VILLAGE, N.H. 03850
1-800-257-2077 IN N.H. 1-603-544-8601
FAX: 1-603-544-8901
E-MAIL: [email protected]
AMPLIFIER
OUTPUTS
+ L - - R +
- L +
- L +
- R +
- R +
SWM-4
(FRONT VIEW)
+ R -
+ R -
+ L -
+ L -
WIRING DIAGRAM
SMW-4
L+ L- R- R+
OUTPUT
L+ L- R- R+
OUTPUT
L+ L- R- R+
OUTPUT
L+ L- R- R+
INPUT
L+ L- R- R+
OUTPUT
2000 - 6/22/00
/