TBS-16535-PGNWC
MADE IN MALAYSIA
Page 2 of 3
1.1-Turn the Table Pedestal stand upside down. Attached the base pedestal leg #1 to pedestal leg #2 using
the provided hardware as shown on Fig.1.
1.2-Attached the this Assemble base Legs (1&2) to the pedestal stand with the provided hardware as shown
on Fig 1.
2.1-Turn table top upside down on a soft protective surface such as a carpet , Attached Table Mounting plate
to the table top using the provided hardware as shown on FIg 2.
2.2- Turn table top upright position and attached the base assembly to the table top using the provided
hardware as show on Fig 3.
ASSEMBLY :
STEP 1
FIg.1
FIg.2
STEP 1
STEP 2
Level Glide
Wrench
Allen Key M5
Allen Key M4
Allen Key M4
Lock Washer
JCBB Bolt
JCBC Bolt
JCBC Bolt
Hex Nut
Lock Washer
Lock Washer
(Small)
Lock Washer (Small)
Flat Washer
Flat Washer
(Small)
Flat Washer (Small)
Flat Washer
T1-NP4257-T-O / T1-NP4257-B-O
SINGLE PEDESTAL TABLE WITH B"FLY LEAF
Reminders :
Two people are needed for assembly.
Use only hardware supplied.
Do not over tighten bolts.
This item may require periodic tightening.
HARDWARE PART :
Wrench
Allen Key
M4
Allen Key
M5
Hex Nut
Flat Washer
Lock Washer
Lock Washer
(Small)
Flat Washer
(Small)
1 pc
1 pc
1 pc
JCBB Bolt
JCBC Bolt
4 pcs
20 pcs
20 pcs
16 pcs
10 pcs
10 pcs
10 pcs