Winners Only DR23636 Assembly Instructions

Type
Assembly Instructions
DPR13636 / DR23636
36 '' ROUND SOLID FIXED TOP PEDESTAL TABLE
WINNERS ONLY
TFS-18595-PGNWU6/7 MADE IN MALAYSIA
Page 1 of 2
This product will take 15-20
minutes to assemble.
Reminders
1.Use only the hardware supplied.
2.Once the product is assemble,level and tighten all the bolts.
3.Do not over-tighten bolts.
4.This item may require periodic tightening
NOTE:
1.Two or two people are needed for assembly
2 please keep all hardware parts out of the reach of children.
Thank you for purchasing this quality product.Be sure to check all packaging material
carefully for small parts that may have come loose inside the carton during shipment.
DR23636-01
DR23636-08
DR23636-07
DR23636-13
DR23636-18
DR23636-22
DPR13636-01
DPR13636-08
DPR13636-08
DPR13636-07
DPR13636-07
DPR13636-13
DPR13636-13
DR23636-13
DR23636-22
DR23636-08
DR23636-07
DPR13636-22
DPR13636-22
DPR13636-18
4 pcs
4 pcs
COMPONENT LIST: HARDWARE LIST:
Flat Washer
Wrench
Lock Washer
Hex Nut 12 pcs
12 pcs
12 pcs
1 pce
PART NO FIGURE DESCRIPTION QTY
Table Top
Pedestal Stand
Pedestal Leg
1 pce
1 pce
1 pce
1
2
3
4
Hardware Bag 1 pce
Mounting Plate
Levelers
PART NO FIGURE DESCRIPTION QTY
Wrench
DPR13636 / DR23636
36 '' ROUND SOLID FIXED TOP PEDESTAL TABLE
WINNERS ONLY
TFS-18595-PGNWU6/7 MADE IN MALAYSIA
Page 2 of 2
Flat Washer
Lock Washer
Hex Nut
Pedestal Stand Pedestal Leg
CARE INSTRUCTION
~ Be sure to use the same type of polish consistenly.
Your furniture will appear cloudy or streaky if oil
based or wax based polishes are interchanged.
~ Spray your furniture surface evenly. Wipe in a
circular motion with a soft clean cloth.
2.1-Align and attach the table top to the base Assembly by inserting Flat Washer(3), Lock Washer(2) and Hex Nut (1), tighten all nuts using
Wrench(4) provided.
ASSEMBLY :
1.1-Turn the Pedestal Stand upside down on a soft protective surface. Attach Leg by inserting pedestal leg through per-drilled holes on
pedestal.
1.2-Use Flat Washer(3), Lock Washer(2), Hex Nuts (1) and Wrench(4) to attached the pedestal Leg to the pedestal stand.
1.3-Repeat step 1.2 For the remaining pedestal legs Leg, once all pedestal leg been attached, turn the base assembly right side up.
STEP 1
STEP 2
3.1- Adjust the levelers until the table sits firmly.
STEP 3
Assembly is now completed.
Mounting plate
Pedestal Stand
Wrench
Lock Washer
Flat Washer
Hex Nut
  • Page 1 1
  • Page 2 2

Winners Only DR23636 Assembly Instructions

Type
Assembly Instructions

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI